Panasonic WV-NW470S, WV-NW474SE operating instructions Mounting the Camera, Optional Heater Unit

Page 10

■Mounting the Camera

Disassembling the Camera

1.Remove the dome cover by loosening the three tamper-proof screws with the supplied bit.

Optional Heater Unit

Assemble the optional heater unit into the camera if necessary. Refer to APPENDIX on page 34 for details.

Adhesive tape

Fold

Supplied screw

Harness

Point "A" (wall)

2.Remove the two red-coloured screws provided for transport protection with a Philips screwdriver.

Mounting the Camera

1.Fix the supplied camera-mounting bracket to the wall/ceiling or a junction box using four screws (locally procured).

2.Perform connections referring to ■ Connections.

3.Fix the camera to the bracket with the three supplied screws.

4.Adjust the image referring to ■ Image Adjustment.

5.A waterproof material such as silicone clay (rubber) or the like should be applied to the screws, screw holes, and other relevant portions if necessary.

Another red screw

Camera mounting screw x3 (Supplied)

Note: Prior to installation, discharge static electricity by placing your hands on a metallic surface. Failure to do so may damage the components inside the cam- era.

-10-

Image 10

Contents WV-NW474SE Risk of Electric Shock Do not Open Contents System Requirements FeaturesPreface TrademarksDocument Convention Never face the camera towards the sun PrecautionsHandle the camera with care Do not aim the camera at the same object for a long timeMajor Operating Controls & Their Functions @4Power cable 8DIP switch@3Control connector @2Video output connectorInstallation space InstallationInstallation Plans & Preparations ProcurementMounting the Camera Optional Heater UnitCable length and wire gauge 24 V AC Type Power ConnectionWire colours & functions AC Type ConnectionsVideo Output Connection Image AdjustmentControl Connector Network Port ConnectionWaterproof Process Connection to Intranet Type Network Connection TypesDirect Connection to PC Type Connection to Internet TypeNetwork Setup of Your PC Preparations for Network ConnectionsNetwork Setup of the Camera Using Panasonic IP Setup SoftwareDhcp DNS DdnsPage Camera Setup Menus Prior to Camera SetupButtons Used for Setup ALL Reset button¡From the Camera Setup Menu Tree Camera Setup Menu CAM Setting ProceduresSetup Selection Camera Identification Camera ID SettingTo edit the Camera ID Light Control Setting ALCCommand Usage To replace a specific character in the Camera IDShutter Speed Setting Shutter Gain Control Setting AGC on DNR-L, DNR-H/OFFElectronic Sensitivity Enhancement Sens UP White Balance Setting White BAL Synchronization Setting SyncATW1 Auto-Tracing White Balance Manual Fine Adjustment for AWC ATW Motion Detector Setting Motion DETAutomatic White Balance Control Mode AWC Push SWMenu/DIP SW Selection Special Menu SpecialTo reset to the factory settings Camera Reset 10-6. BWNetwork Setup Network Setup Http Port NumberInitializing the Camera Menu Initializing the Setup MenuInitializing Initializing Html FilesTroubleshooting Prevention of Blooming and Smear SpecificationsTCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP Network SectionGeneral Standard AccessoriesOptional Accessories WV-NW474SEAppendix Optional Heater Unit WV-CW3HE在日本印刷