Panasonic WV-NW474SE, WV-NW470S operating instructions Major Operating Controls & Their Functions

Page 7

MAJOR OPERATING CONTROLS & THEIR FUNCTIONS

u i

A

q w

!0

!1

LED ON

 

 

 

B

o

 

 

LED OFF

 

!2

LINK RCV

 

 

LEFT

 

!3

RIGHT

 

!4

UP

 

!5

DOWN

 

!6

 

 

A LED ON B

LINKRCV LEDOFF

LEFT

RIGHT

UP

DOWN

Transport Protection Screws (Red)

!8

!7

SET

!9

SET

y

t r e

qTilting lock screw Fixes the tilting position.

wPanning table

Adjusts the panning angle of the camera.

eAzimuth adjuster

Adjusts the azimuth angle to level the image.

rPan lock screw

Fixes the panning position.

tZoom lock lever

Fixes the zoom position after adjustment.

yFocus lock lever

Fixes the focus position after adjustment.

uOptional heater connector

When an optional heater unit is installed in the cam- era, the harness exiting from the unit will be con- nected to this.

iReset button (A)

Holding down the Up and Down buttons simultane- ous for 15 seconds in the power-on state will reset the network setup parameters.

Note: Never press both reset buttons A and B at the same time.

oReset button (B)

!0LED switch

ON: Enables the LINK and RCV LEDs to

ON

 

indicate the communication status.

 

OFF: Disables the status indication.

 

Note: Normally set the switch to OFF. Set it

OFF

to ON only when you check the communication status. Failure to do so may cause disturbance to the camera image, or light leakage to the outside of the camera in dark places.

!1Link indicator (LINK)

Lights up when establishing communications via the network if the LED switch is set to ON.

!2Receive indicator (RCV)

Lights up when receiving data via the network if the LED switch is set to ON.

!3Left button (Left)

Moves the cursor to the left, selects the mode, and adjusts some levels.

!4Right button (Right)

Moves the cursor to the right, selects the mode, and adjusts some levels.

!5Up button (Up)

Moves the cursor upward and selects items in the menu setup.

!6Down button (Down)

Holding down the Up and Down buttons simultane- ously for 15 seconds in the power-on state will reset the HTML files and alarm mail setup.

-7-

Moves the cursor downward and selects items in the menu setup.

Image 7
Contents WV-NW474SE Risk of Electric Shock Do not Open Contents Trademarks FeaturesPreface System RequirementsDocument Convention Do not aim the camera at the same object for a long time PrecautionsHandle the camera with care Never face the camera towards the sunMajor Operating Controls & Their Functions @2Video output connector 8DIP switch@3Control connector @4Power cableProcurement InstallationInstallation Plans & Preparations Installation spaceOptional Heater Unit Mounting the CameraConnections Power ConnectionWire colours & functions AC Type Cable length and wire gauge 24 V AC TypeNetwork Port Connection Image AdjustmentControl Connector Video Output ConnectionWaterproof Process Connection to Internet Type Network Connection TypesDirect Connection to PC Type Connection to Intranet TypePreparations for Network Connections Network Setup of Your PCUsing Panasonic IP Setup Software Network Setup of the CameraDdns Dhcp DNSPage ALL Reset button Prior to Camera SetupButtons Used for Setup Camera Setup Menus¡From the Camera Setup Menu Tree Camera Identification Camera ID Setting Setting ProceduresSetup Selection Camera Setup Menu CAMTo replace a specific character in the Camera ID Light Control Setting ALCCommand Usage To edit the Camera IDShutter Speed Setting Shutter Gain Control Setting AGC on DNR-L, DNR-H/OFFElectronic Sensitivity Enhancement Sens UP White Balance Setting White BAL Synchronization Setting SyncATW1 Auto-Tracing White Balance Push SW Motion Detector Setting Motion DETAutomatic White Balance Control Mode AWC Manual Fine Adjustment for AWC ATWSpecial Menu Special Menu/DIP SW Selection10-6. BW To reset to the factory settings Camera ResetHttp Port Number Network Setup Network SetupInitializing Html Files Initializing the Setup MenuInitializing Initializing the Camera MenuTroubleshooting Network Section SpecificationsTCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP Prevention of Blooming and SmearWV-NW474SE Standard AccessoriesOptional Accessories GeneralOptional Heater Unit WV-CW3HE Appendix在日本印刷