Panasonic WV-NW474SE, WV-NW470S operating instructions Waterproof Process

Page 13

3. Zoom

•Unlock the zoom lever.

•Move the lever to adjust the zoom.

•Lock the lever.

Focus lock lever

	NEAR
	FAR
Zoom lock lever	WIDE
	TELE

4. Focus

•Unlock the focus lever.

•Move the lever to adjust the focus.

•Lock the lever.

5. Reinstalling the dome cover

•Attach the dome cover to the camera so that the two position marks match.

•Tighten the three tamper-proof screws.

●Waterproof Process

If necessary, apply waterproof process to protect the camera from water soak.

•Power cord

Tape individual wires first, and finally all of them as a whole.

Power cord

•Connector junctions

Tape the junction points of BNC-BNC, control con- nector-adapter, and network connector-adapter.

Video output cable

•Gaps and holes

Apply such a waterproof material as silicone clay (rubber) to the screws, screw holes, and other rele- vant portions.

-13-

Image 13

Contents WV-NW474SE Risk of Electric Shock Do not Open Contents Preface FeaturesSystem Requirements TrademarksDocument Convention Handle the camera with care PrecautionsNever face the camera towards the sun Do not aim the camera at the same object for a long timeMajor Operating Controls & Their Functions @3Control connector 8DIP switch@4Power cable @2Video output connectorInstallation Plans & Preparations InstallationInstallation space ProcurementOptional Heater Unit Mounting the CameraWire colours & functions AC Type Power ConnectionCable length and wire gauge 24 V AC Type ConnectionsControl Connector Image AdjustmentVideo Output Connection Network Port ConnectionWaterproof Process Direct Connection to PC Type Network Connection TypesConnection to Intranet Type Connection to Internet TypePreparations for Network Connections Network Setup of Your PCUsing Panasonic IP Setup Software Network Setup of the CameraDdns Dhcp DNSPage Buttons Used for Setup Prior to Camera SetupCamera Setup Menus ALL Reset button¡From the Camera Setup Menu Tree Setup Selection Setting ProceduresCamera Setup Menu CAM Camera Identification Camera ID SettingCommand Usage Light Control Setting ALCTo edit the Camera ID To replace a specific character in the Camera IDShutter Speed Setting Shutter Gain Control Setting AGC on DNR-L, DNR-H/OFFElectronic Sensitivity Enhancement Sens UP White Balance Setting White BAL Synchronization Setting SyncATW1 Auto-Tracing White Balance Automatic White Balance Control Mode AWC Motion Detector Setting Motion DETManual Fine Adjustment for AWC ATW Push SWSpecial Menu Special Menu/DIP SW Selection10-6. BW To reset to the factory settings Camera ResetHttp Port Number Network Setup Network SetupInitializing Initializing the Setup MenuInitializing the Camera Menu Initializing Html FilesTroubleshooting TCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP SpecificationsPrevention of Blooming and Smear Network SectionOptional Accessories Standard AccessoriesGeneral WV-NW474SEOptional Heater Unit WV-CW3HE Appendix在日本印刷