■Camera Cleaning
Even if this function is used, noise may be produced on the monitor screen, or the preset position may deviate in the course of prolonged use.
In such cases, activate the refresh mode on the special 2 menu. (See page 42.)
To use this camera with
■Preset Data Uploading or Down-
loading
To download the preset data from the camera to the controller or upload the downloaded data to the camera, set the following functions to OFF.
Downloading or uploading the data may not work normally if these functions are set to ON.
•Alarm (see page 31)
•Preset alarm (see page 33)
•Cleaning (see page 32)
•Motion detection (see page 39)
•Auto mode (see page 23)
•Self return (see page 23)
Aim the camera at a motionless object such as a wall, if possible, to download or upload the preset data.
Note: Take notice of the following when uploading the downloaded data to the camera.
•Preset positions may vary. If a preset position has deviated, delete the preset position and set the correct preset position newly.
•Uploading of
PRECAUTIONS
1.Do not attempt to disassemble the camera.
To prevent electric shock, do not remove screws or covers.
There are no
2.Handle the camera with care.
Do not misuse the camera. Avoid striking, shaking, etc. The camera could be damaged by improper handling or storage.
3.Do not expose the camera to rain or moisture, nor try to operate it in wet areas.
This product is designed for indoor use or locations where it is protected from rain and moisture.
Turn the power off immediately and ask qualified service personnel for servicing.
Moisture can damage the camera and also create the danger of electric shock.
4.Do not use strong or abrasive detergents when cleaning the camera body.
Use a dry cloth to clean the camera when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe gently. Care should be taken not to scratch the dome cover when wiping it.
Afterwards, wipe off the remaining detergent with a dry cloth.
5.Never aim the camera at the sun.
Whether or not the camera is in use , never aim it at the sun or other extremely bright objects. Otherwise, blooming or smear may be caused.
6.Never aim the camera at strong light sources for an extended period of time.
A light source such as a spot light causes
7.Do not install this camera upside down.
This camera is designed for mounting on the ceiling or wall. Using this camera installed upside down, for example, mounted on the floor, may cause malfunction.
8.If "OVER HEAT" appears on the monitor screen. The temperature inside the camera exceeds the normal level because of a malfunction of the cooling fan or other reasons. If this happens, turn the power off immediately and refer servicing to qualified service personnel.