Samsung SCC-C6453N Auto SET, Auto Pan Setup, You can set the Auto PAN, PATTERN, and Auto Play

Page 37

M

The preset position can be specified for a tilt range of between 0° and 90°.

 

Those presets that are out of a tilt of 90° can not be specified.

 

If you try to specify a preset position for a range exceeding a tilt of 90° using a

 

controller (SSC-1000, 2000 or 5000), you will see a message of <SET AGAIN> on

 

the screen. If this is the case, try again for a range below a tilt of 90°.

 

If you upload/download the menu setting using SSC-1000, 2000 or 5000, the preset

 

may differ from the menu setting so define the preset again after the operation.

AUTO SET

You can set the AUTO PAN, PATTERN, and AUTO PLAY.

M

If you upload/download the menu setting using SSC-1000, 2000 or 5000, the

 

settings for AUTO PAN, PATTERN, SCAN, and PRESET may differ from the menu

 

settings so define them again after the operation.

Auto Pan Setup

Set the starting and ending positions to patrol between points at specified speed.

For selecting and saving each menu item, refer to “How to use the keyboard controller”. (page 20)

1. Select <MAIN MENU>-<AUTO SET>.

 MAIN MENU 

PROFILE

CAMERA SET

INTELLIGENCE PRIVACY ZONE PRESET AUTO SET ZONE SET ALARM SET CLOCK SET OTHER SET

English

2.Select the number of <AUTO PAN>. AUTO PAN setup screen appears.

AUTO SET

AUTO PAN

1

2

3

4

PATTERN

 

123

SCAN

1

2

3

4

AUTO PLAY

 

 

 

OFF

English _37

00890A-NA_SCC-C6453N-ENG.indb 37

2009-08-05 오후 3:03:

Image 37
Contents Smart Dome Camera Overview English  Overview FCC Statement Important safety instructions Contents What’s Included FeaturesCamera At a GlanceFrame SET Installation Preparing InstallationInsert the cable into the Frame SET, and close the Adaptor Screw Fixing Hole DiagramProtective Tape from on the lens Button Frame SET Cover Camera Camera Address Setup Initial SetupCommunication Protocol Setup Use SW606, SW605, and SW604 to specify the camera addressSetting RS-422A/RS-485 Termination Baud Rate SetupUse pins #5, #6 of SW603 to set the baud rate Factory default is 9600 BPSSame address in the network RS-422A/RS-485 Full Duplex OrganizationConnecting to a monitor Connecting with Other deviceVideo terminal on the rear of monitor BNC Cable To connect Alarm OUT To connect AlarmTo connect the controller Power Supply Connecting the adaptor cableAdaptor Board Using OSD icons How to use the keyboard controllerCamera will resume the last run operation Main Menu  ITS ProfileNight Camera SET You can configure the general settings of the camera moduleCamera ID  Location Specify the display position of the camera IDWith this, you can adjust the AGC level of a  Manual Adjust the iris level manuallyIris AGCDNR MotionShutter SENS-UPFlickerless You can specify a recording mode according to the sceneXDR DAY/NIGHTNeeded Auto Switch or Auto FocusSET-AUTO SET are not available White BAL DAY/NIGHT Display Zoom Zoom SpeedDisplay P/T Digital ZoomAGC Color SUP SyncReverse POSI/NEGAWhen multiple motions continue arbitrarily You can enable the motion detection and tracking functionsIntelligent Video AdvancedAlarm OUT ResolutionPrivacy Zone DisplayPreset Select Position and adjust PAN Select the preset numberSettings so define them again after the operation Auto Pan SetupAuto SET You can set the Auto PAN, PATTERN, and Auto PlayPosition Direction Left Endless OFF Speed Scan Setup Pattern SetupSelect the Start and move the camera using pan/tilt/zoom ~ 511 for Preset Auto Play SetupYou can set the north direction and the zone coverage Zone SETSelect Main MENU-ZONE SET Select Main MENU-ALARM SET Alarm SET Auto SET Sets the pattern and scan Other SET Clock SETPassword Factory DefaultsOSD Color Proportional P/TSystem Info CommunicationYou can check the system information Select Main MENU-SYSTEM InfoYou can set the language of the user interface LanguageFunction Key Shortcut KeysSpecifications Description PAN range 360˚Endless Preset Pan Speed 600˚/sec, maximumManual Pan Speed 0.01˚~ 180˚/sec Tilt range -6˚~186˚Product Appearance 00890A-NASCC-C6453N-ENG.indb 2009-08-05 오후