Icom IC-R3 Programming after selection, Transferring memory contents to another memory

MEMORY CHANNELS 5

■Programming after selection

qSelect memory mode with [V/M].

wSet the memory channel to be programmed with [DIAL].

•Rotate [DIAL] while pushing [FUNC] to select a memory bank (A–H) or programmed scan edge channel.

•Non-programmed channels cannot be selected.

ePush [V/M] to select VFO mode. r Set the desired frequency:

➥Select the desired band with [↔].

➥Set the frequency using [DIAL].

➥Set other data (e.g. offset frequency, duplex direction,

tone squelch frequency, etc.), if required.

tPush [V/M] for 2 sec. to program the selected channel.

•Keep pushing for 2 sec. or more to automatically select the next memory channel, if desired.

■Transferring memory contents to another memory

qSelect memory mode with [V/M].

wSelect the memory channel to transfer with [DIAL].

•Rotate [DIAL] while pushing [FUNC] to select a memory bank (A–H) or programmed scan edge channel.

ePush [V/M] for 1 sec. to indicate memory channels.

•Do not hold [V/M] for more than 2 sec., otherwise the memory channel contents will be transferred to VFO.

rRotate [DIAL] to select the channel to transfer to.

•Rotate [DIAL] while pushing [FUNC] to select a memory bank or programmed scan edge channel.

•VFO (VF), as well as regular memory channels, can be trans- ferred in this way.

tPush [V/M] for 2 sec. to transfer.

[EXAMPLE]: Transferring memory channel 3 (memory bank A) to 20 (memory bank A).

	FM	M:A03		FM	M: VF			M:A20		FM	M:A20
	146.340.000			146.340.000		FUNC		. .		146.340.000
	TS	15.0		TS	15.0	+	TS	.		TS	15.0
	S1 3 5 7 9		V/M SKIP	S1 3 5 7 9			S1 3 5 7 9			S1 3 5 7 9
V/M SKIP									V/M SKIP
	VOL		for	VOL			VOL			VOL
Select memory						for bank	for CH		for 2 sec.
			1 sec.
						selection	selection
channel	FM			FM						FM

blank channel

15