Sharp MD-MT866H operation manual Operation, Helpful tip when attaching a label, Recording, Basic

Page 23

To prevent recorded MiniDiscs from be- ing erased accidentally

Slide the accidental erase prevention tab, located on the side of the MiniDisc, in the direction indi- cated by the arrow.

●The MiniDisc will then be protected against accidental erasure.

Helpful tip when attaching a label

When attaching a label to an MiniDisc cartridge, be sure to note the following. If the label is not attached properly, the MiniDisc may jam inside the unit and it may not be pos- sible to remove it.

●If the label peels off or partially lifts

away, replace it with a new one.

● Do not put a new label on top of an existing one.

●Attach the label only in the specified location.

Recording –

Operation

Recordable Recording

prevented

To add a recording to such a MiniDisc, slide the acci- dental erase prevention tab back to its original position.

Web-site:www.sharp.co.uk/support Help Line: 08705 274277 (office hours)

Basic –

Image 23

Contents Thank you for purchasing this Sharp product MD-MT866HAccessories Contents Special Notes Special NotesImportant Introduction Introduction Storing the unit PrecautionsPrecautions Avoid using or leaving the unit in the following placesMain unit Names of Controls and IndicatorsMain unit display panel Important Introduction Names of Controls and IndicatorsNames Remote control unitRemote control display panel IndicatorsFace the top Charge Toward you Mode Battery ChargerBattery- Charger Names Setting For use with the AC adaptor How to use the Charge / Operation switchBattery RemovingCharging Using with the Rechargeable BatteryPower Source Using with the Rechargeable Battery Display Conditions PowerAbout the liquid crystal display LCD About charging time Source Using with the AC AdaptorUsing with Operation modeRelease Lock Open PressHold Function Hold FunctionPreparation Inserting a MiniDisc Inserting a MiniDiscTo the DC in 5V socket To the Optical Line in socket ConnectionsConnections You can record your favorite CDs or tapes to an MDTo the Optical Line in socket To the DC50/60Hz 5V socket To the wall socket Before Recording RecordingBasic Operation Recording +12 -12dB Press the REC buttonDigital recording About the TOC To update the recorded contents of the MiniDiscTo interrupt recording To stop recordingBasic Helpful tip when attaching a labelOperation RecordingBefore Playing back PlaybackBasic PlaybackTo interrupt playback Volume controlTo turn off the power Bass controlTo locate the beginning of a track Advanced PlaybackTo return to normal playback Useful Features Advanced PlaybackRandom play or repeat play To interrupt fast playbackAdvanced Recording Start recording Useful Features Advanced RecordingPress the Mode button whilst the record- ing is paused Long-play recording monaural recordingYou can erase a portion of a track and make a new recording Press the right shuttle switch toward ENTER/SYNCYou can create your own track numbers at any point When a recording is paused or whilst recording…To create your own track numbers Recording tracks as a single trackAbout sampling rate converter About track numbersTo record from a microphone Useful Features Recording from a MicrophoneTo write recorded contents on the MiniDisc Recording from a MicrophoneRecording from a Microphone During a mic synchro recording UsefulTrack intervals During a mic manual recordingDuring playback, press the Disp button Useful Features Checking DisplaysChecking Displays To check the elapsed time and remaining time of the trackPress the Disp button to display the play To display the playing time of an indiVidual track Track number and track nameChanging Changing Default SettingsFeatures Default SettingsAuto play Display backlight on the remote controlAuto power save Beep soundTitling a Titling a MiniDiscAdvanced MiniDiscTo add characters Characters symbolsTo erase a character To enter a spaceBefore stamping What is a master MiniDisc?What is a MiniDisc for stamping? Stamping titles from another MiniDiscOperation of the MiniDisc for stamping To erase tracks one at a time Advanced FeaturesPress the right shuttle switch toward ENTER/SYNC again Editing a Recorded MiniDiscPress the Edit button repeatedly to select Combine To divide a trackTo combine tracks Press the Edit button repeatedly to select DivideTo move a track AD-CA55X White RedRechargeable battery Other Features and CautionReferences Other Features and Caution Resuming auto play MiniDisc System Limitations Symptom LimitationsReferences Error MessagesError Messages Tr. Protect No SignalTroubleshooting TroubleshootingMoisture condensation MaintenanceMaintenance If trouble occursSpecifications SpecificationsError correction DimensionsWeight Signal readoutSharp Corporation