8
Certifying the Installation
Prior to determining that an installation is complete, test the handsets following the sequence given in Chapter 6 Testing a Handset and conduct a Site Survey mode test according to the directions given in Chapter 7 Diagnostic Tools.
The installation may need some adjustments. Note any areas where coverage is conflicting or inadequate. Note any system difficulties and work with your wireless LAN and/or LAN system administrator to determine the cause and possible remedy. See Chapter 10 Troubleshooting for clues to possible sources of difficulties. If any adjustments are made to the system,
The installer should not leave the site before performing installation verification.
These tests must be performed in typical operating conditions, especially if heavy loads occur. Testing sequence and procedure is different for every installation. Generally, you should organize the test according to area and volume, placing numerous calls to others who can listen while you perform coverage tests. Note any areas with excessive static or clarity problems and report it to a Polycom service engineer.
The coverage test will also require you to put the handset in Site Survey mode and walk the entire coverage area to verify all APs.
Conducting a site survey
Conduct a site survey of the installation, by walking the site looking for interfering 802.11 systems, adequate coverage and channel assignment, and correct AP configuration.
1.Referring to Run Site Survey, put a handset into Site Survey in the Any/Smry ESSID mode. Walk throughout the site checking for any expected APs or other ESSIDs.
2.Then, walk the site again, in MyID/Smry ESSID mode, this time checking that every location has adequate coverage (there should
PN: | 83 |
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 | Fax: +44 (0)1245 808299 |