SpectraLink 8002 manual Do not Power, Off

SpectraLink 8002 Wireless Telephones Configuration and Administration (SIP)

Message	Description	Action
DO NOT POWER	The handset is in a critical section	None. Do not remove the Battery Pack or
OFF	of the software update.	attempt to power off the phone while this is
		displayed. Doing so may render the
		handset inoperable.
Duplicate IP	The handset has detected another	If using DHCP, check that the DHCP
	device with its same IP address.	server is properly configured to avoid
		duplicate addresses.
		If using Static IP, check that the handset
		was assigned a unique address.
Erase Failed	Download process failed to erase	Operation will retry but may eventually
	the memory in the handset.	report the error "int. error: 0F" Power cycle
		the handset.
Erasing Memory	Handset has determined that a	None. When the progress bar fills the
	download should occur and is	display line the erase operation is
	erasing the current software from	complete.
	memory.	Do not remove the Battery Pack or attempt
		to turn the handset off during this
		operation.
Files Too Big	Handset software download files	Download new software per Software
	are incorrect or corrupted.	Maintenance.
Flash Config Error	Handset internal configuration is	Perform "Restore Defaults" operation via
	corrupt.	administrator menus (or re-program with
		Configuration Cradle).
Initializing …	The handset is performing power-	None. This is informational only.
	on initialization.
Internal Err. # #	The handset has detected a fault	Record the error code so it can be
	from which it cannot recover.	reported.
		Turn the	handset off		then	on	again.
		If error persists, try registering a different
		handset	to	this	telephone		port.
		If error still persists, contact Polycom
		Technical Support and report the error.
Must Upgrade SW!	Handset software is incompatible	Download new software from the
	with hardware.	SpectraLink		website	per	Software
		Maintenance.
No DHCP Server	Handset is unable to contact the	Check that your DHCP server is
	DHCP server.	operational and connected to WLAN or use
		Static IP configuration in the handset.
No ESSID	Attempted to run Site Survey	Statically configure an ESSID in the Admin
	application without an ESSID set.	menu.
No Func Code	Handset software is incorrect or	Reconfigure the handset to gain access to
	corrupted.	the WLAN and download new handset
		software.

92 PN: 1725-36034-001_B.doc

VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299