Vision Fitness T9700, T9300, T9200, T9350 manual T9600HRTCOMFORT/T9600HRT/T9500HRT/T9450HRT

Page 17

T9600HRT(COMFORT)/T9600HRT/T9500HRT/T9450HRT/

T9350/T9300 TREADMILLS ( for Software Ver. 5.9)

Apply to :

1.VISION T9300/T9350/T9400/T9450/T9500 serise treadmail.

2.2004 year T9300/T9350/T9450/T9500/T9600 serise treadmail.

3.2004 year T9350/T9450/T9500 for ID

How to enter into the engineering mode?

1. Press & Hold both “ELEVATION UP” and“SPEED DOWN” at the same time for3-5 sec. Then, the dot vision display will show

DGAJ n0nE” .

2. Press the "ELEVATION" or "SPEED" to select you want and press the "SELECT" key enter.

Display show	function interpret
ENG1	set the treadmill all parameter
ENG2	console LED test mode
ENG3	treadmill running test mode
ENG4	Auto-calibration mode
ENG5	speed sensor test mode
NONE	come back the user mode

3-4

Image 17

Contents Page Table of Contents Section Preventive Maintenance Schedule Drive Belt Running BeltProcedure Deck RE-WAXING ProcedureClean the Grooves Procedure Lubricating the AIR Shock Wiring Diagram Instruction T9700TM51D/E MCB Wiringfor 110V T9300 MCB Wiringfor 110V T9200/T9250 MCB Wiringfor 110V Console Engineering Mode Guide T9700TM51D/E Treadmills for Software Ver KEY Behale Function Remarks T9600HRTCOMFORT/T9600HRT/T9500HRT/T9450HRT Select SOU=SOURCES Parameter SCO=SCOPE Parameter 10MIL Remarks T9200/T9250 Treadmills for Software Ver. S706 Sources MCB LED Instructions MCB LED Indication MCB MCB LED Indication PWM MCB LED Chart MCB LED-AIDED Troubleshooting Chart Troubleshootings Possible causes No display on consoleRunning speed is not stable All or some of the keys on console do not work Treadmill starts to run by itselfFix Noises generated under motor coverTreadmill will not start Incline function does not work Heart-Rate-Control function does not work T9700 TM51D/E Error code definition Error Messages on the ConsoleTroubleshootings T9200/T9250 Error code definition Software Upgrade Procedure Vision Series Treadmill Software Upgrade SOP Steps