Vision Fitness T9350, T9600, T9500, T9450, T9700, T9300, T9200 manual MCB LED Indication

MCB LED Indication

Note:

the incline is being commanded up

Note:

the incline is being commanded down

UP Light- Indicates the PCB is commanding the incline motor to move up. If the User is

commanding the incline to increase and this light is not lit, check cabling, verify proper PCB operation and replace it if either is defective. If the problem persists, replace the MCB. If the light is lit but the incline is not moving, check and verify incline motor and its connection to the board; check fuse F2. If this problem persists replace MCB.

DN Light- Indicates the PCB is commanding the incline motor to move down. If the User is

commanding the incline to decrease and this light is not lit, check cabling, verify proper PCB operation and replace it if either is defective. If the problem persists, replace the MCB. If the light is lit but the incline is not moving, check and verify incline motor and its connection to the board; check fuse F2. If this problem persists replace MCB.

4-3