Vision Fitness T9700, T9600, T9500, T9450, T9300, T9200, T9350 No display on console, Possible causes

No display on console

Possible causes:

1.Breaker is damaged.

2.ON/OFF switch is damaged.

3.MCB is damaged.

4.6-pin console cable is damaged.

5.PCB is damaged.

Fix:

1.( refer to “MCB LED layout & indication”……SECTION 6) Verify if LED 115vAC(AC) is lit. If this LED is lit, go to step 2.

If LED 115vAC(AC) is not lit, verify the following:

A B

2. The switch is turned to the "ON" position.

￿Inspect the circuit breaker to see if it has tripped off.

( If it is tripped off….like diagram B,

reset the breaker. And check which part is short-circuited. Then replace the short-circuited part.)

( If the switch light isn't lit, replace the switch.)

￿Verify wire connection AC1 & AC2 on the MCB.

( refer to “wiring diagram”…….page 4-3 )

￿Verify the ON/OFF switch, breaker & socket wires are connected. 3. Verify if LED +11v & +18v is lit. If one is not lit, replace MCB.

4.Replace console cable.

5. Replace PCB.

5-1