Vision Fitness T9500, T9600, T9450, T9700, T9300, T9200, T9350 manual Steps

Page 43

B. Steps:

2.Connection cables & short pin is ready.

3.Turn ON the power switch.

4.Find out the software version file in the computer and then actuate/open the file by “click” the mouse twice.

5.The computer will be turned into DOS mode, and run the installation work. Automatically. (It takes around 2 minutes for installation.)

6.After competed installation, the computer will show passing on the computer screen.

7.Turn OFF the power switch.

8.Disconnect the cables.

9.Turn ON the power switch and then enter into the engineering mode to confirm if the software

had been installed/upgraded.

6-2

Revision: 1.0 Date: 1999-09-01

Image 43

Contents Page Table of Contents Section Preventive Maintenance Schedule Drive Belt Running BeltProcedure Deck RE-WAXING ProcedureClean the Grooves Procedure Lubricating the AIR Shock Wiring Diagram Instruction T9700TM51D/E MCB Wiringfor 110V T9300 MCB Wiringfor 110V T9200/T9250 MCB Wiringfor 110V Console Engineering Mode Guide T9700TM51D/E Treadmills for Software Ver KEY Behale Function Remarks T9600HRTCOMFORT/T9600HRT/T9500HRT/T9450HRT Select SOU=SOURCES Parameter SCO=SCOPE Parameter 10MIL Remarks T9200/T9250 Treadmills for Software Ver. S706 Sources MCB LED Instructions MCB LED Indication MCB MCB LED Indication PWM MCB LED Chart MCB LED-AIDED Troubleshooting Chart Troubleshootings Possible causes No display on consoleRunning speed is not stable All or some of the keys on console do not work Treadmill starts to run by itselfFix Noises generated under motor coverTreadmill will not start Incline function does not work Heart-Rate-Control function does not work T9700 TM51D/E Error code definition Error Messages on the ConsoleTroubleshootings T9200/T9250 Error code definition Software Upgrade Procedure Vision Series Treadmill Software Upgrade SOP Steps