Vision Fitness T9300, T9600, T9500, T9450, T9700, T9200, T9350 manual Running speed is not stable

Page 32

Running speed is not stable

Possible causes:

1.AC power voltage is too low.

2.Tension of drive belt or running belt is too loose.

3.Poor adjustment of MCB.

4.MCB is damaged.

5.Motor is damaged.

Fix:

1.Check the power voltage by using voltage-meter to see if it is within 120V 15% or 230V15%.

If the power voltage isn't within the range, look for a qualified

electrician for help.

2.Open the motor cover, if the belt has stretched and is slipping across the rollers when running.

Adjust the belt tension.

3. Remove the motor cover and run the machine at low speed, then adjust the IR COMP of MCB.

If it hasn't been improved, replace new MCB.

4. Replace new motor.

5-2

Image 32

Contents Page Table of Contents Section Preventive Maintenance Schedule Running Belt Drive BeltDeck RE-WAXING Procedure ProcedureClean the Grooves Procedure Lubricating the AIR Shock Wiring Diagram Instruction T9700TM51D/E MCB Wiringfor 110V T9300 MCB Wiringfor 110V T9200/T9250 MCB Wiringfor 110V Console Engineering Mode Guide T9700TM51D/E Treadmills for Software Ver KEY Behale Function Remarks T9600HRTCOMFORT/T9600HRT/T9500HRT/T9450HRT Select SOU=SOURCES Parameter SCO=SCOPE Parameter 10MIL Remarks T9200/T9250 Treadmills for Software Ver. S706 Sources MCB LED Instructions MCB LED Indication MCB MCB LED Indication PWM MCB LED Chart MCB LED-AIDED Troubleshooting Chart Troubleshootings No display on console Possible causesRunning speed is not stable Treadmill starts to run by itself All or some of the keys on console do not workNoises generated under motor cover FixTreadmill will not start Incline function does not work Heart-Rate-Control function does not work Error Messages on the Console T9700 TM51D/E Error code definitionTroubleshootings T9200/T9250 Error code definition Software Upgrade Procedure Vision Series Treadmill Software Upgrade SOP Steps