Vision Fitness T9500, T9600, T9450, T9700, T9300, T9200, T9350 MCB LED-AIDED Troubleshooting Chart

MCB LED-AIDED TROUBLESHOOTING CHART

NO.	PROBLEM/RESULT		CORRECTIVE ACTION
1	No operation of	MCB or PCB	Verify connections, power switch, circuit
			breaker and fuse
2	No operation of	MCB or PCB	Check fuse F1
3	PCB will not power up		Replace MCB
4	PCB will power up but the MCB		Verify adequate line voltage. If line voltage is
			adequate, MCB is damaged and needs to be
	will not operate
			returned to manufacturer.
			Verify connections to motor and the motor
			itself. If the motor and its connections are
			good, the MCB should be replace. Return
			MCB to manufacture with information on
5			location. Power level, how it was used when
	Will not operate the motor		failure occurred etc.
			The motor can be verified by disconnection
			the motor; connecting a volt-ohm meter(set to
			VCD) to the motor leads; and spinning the
			tread and observing a voltage. If no voltage,
			Bad motor.
			A 5-second current limit time-out has occurred.
6			Resets console or cycle power to correct.
	Will not operate the motor		Check treadmill for excessive wear or
			mechanical defects. If problem persists, return
			MCB.
			The MCB is experiencing a discontinuous over
7			current events. Check for mechanical wear
	MCB in current limit mode		and/or defective motor. If on mechanical wear
			and motor good, replace MCB and return
			defective MCB to manufacturer.
8			Check and verify the J2 and J3 cables are
	Will not operate the motor		good, replace the PCB. If the problem
			persists, replace the MCB.
9	Incline does not move		Verify connections to the J3 & incline motor. If
			the connections look good, check F2.
10	Incline does not move		Verify connections to the J3 & incline motor. If
			the connections look good, check F2.

4-5