Vision Fitness T9600, T9500, T9450, T9300, T9200, T9350 manual T9700TM51D/E Treadmills for Software Ver

Page 14

T9700(TM51D/E) TREADMILLS (for Software Ver. 2.5)

Apply to :

1.VISION T9700/T9600 serise treadmail .

2.2004 year T9700 serise treadmail.

3.2004 year for ID

How to enter into the engineering mode?

1.Press & Hold both “ELEVATION UP” and “SPEED DOWN” at the same time for 3-5 sec. Then, the dot vision display will

show “DGB1J A564” and right display is show VERSION ”

2.Press the "ELEVATION" or "SPEED" to selectyou want and press the "SELECT" key enter.

Display show	function interpret
CONFIGURE	set the treadmill all parameter
DISPLAY TEST	console LED test mode
BURN IN TEST	treadmill running test mode
AUTO CAL	Auto-calibration mode
SPEED SENSOR	speed sensor test mode
RS 232 TEST	RS-232 test mode
HR TEST	HR test mode

3-1

Image 14

Contents Page Table of Contents Section Preventive Maintenance Schedule Running Belt Drive BeltDeck RE-WAXING Procedure ProcedureClean the Grooves Procedure Lubricating the AIR Shock Wiring Diagram Instruction T9700TM51D/E MCB Wiringfor 110V T9300 MCB Wiringfor 110V T9200/T9250 MCB Wiringfor 110V Console Engineering Mode Guide T9700TM51D/E Treadmills for Software Ver KEY Behale Function Remarks T9600HRTCOMFORT/T9600HRT/T9500HRT/T9450HRT Select SOU=SOURCES Parameter SCO=SCOPE Parameter 10MIL Remarks T9200/T9250 Treadmills for Software Ver. S706 Sources MCB LED Instructions MCB LED Indication MCB MCB LED Indication PWM MCB LED Chart MCB LED-AIDED Troubleshooting Chart Troubleshootings No display on console Possible causesRunning speed is not stable Treadmill starts to run by itself All or some of the keys on console do not workNoises generated under motor cover FixTreadmill will not start Incline function does not work Heart-Rate-Control function does not work Error Messages on the Console T9700 TM51D/E Error code definitionTroubleshootings T9200/T9250 Error code definition Software Upgrade Procedure Vision Series Treadmill Software Upgrade SOP Steps