HOW TO USE CUSTOM PROGRAMS
1 Insert the key fully into the console.
See GETTING STARTED on page 10.
2 Select one of the custom programs.
When the key is in- serted, the manual
mode will be selected and the Manual indica- tor will light. To select one of the custom pro-
grams, press the Select
Program button r epeatedly until the Learn 1 or Learn 2 indicator lights.
When a custom program is selected, the program display will show a simplified profile of the pro- gram. The Time/Laps display will show how long the program will last.
Press the Start Program button or the Speed +
3 button to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.
Each program is divided into several
speed setting for the first segment will be
shown in the flashing Current Segment col- umn of the program dis- play. (The incline set-
tings are not shown in
the program display.) The speed settings for the next five segments will be shown in the five columns to the right.
When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash, a se- ries of tones will sound, and all speed settings will move one column to the left. The speed setting for the second segment will then be shown in the flashing Current Segment column and the tread-
mill will automatically adjust to the speed and in- cline settings that you programmed previously.
The program will continue until the speed setting for the last segment is shown in the Current Segment column and no time remains in the Time/Laps display. The walking belt will then slow to a stop.
Note: If the program is too easy or too difficult, the
speed or incline setting for the current segment can |
| ||
be adjusted with the Speed or Incline buttons. |
| ||
Adjustments will not be stored in memory. To | repro- | ||
gram | the speed or incline setting for the current seg- | ||
ment, press the Record button. The indicator on the |
| ||
button will light. | Speed and incline settings can be | ||
programmed only when the indicator is lit. | (Note: | ||
When the indicator on the Record button is lit, the |
| ||
Time/Laps display will show the elapsed time in- |
| ||
stead of the time remaining in the program.) | Adjust | ||
the speed or incline setting for the current segment |
| ||
with the Speed or Incline buttons. | After the segment | ||
is completed, | press the Record button again. The | ||
new setting will be stored in memory.
To stop the program temporarily, press the Stop button. All displays will pause and the Time/Laps display will begin to flash. To restart the program, press the Start Program button or the Speed + button. To end the program, press the Stop button, remove the key, and then reinsert the key.
4 Follow your progress with the displays.
Refer to step 5 on page 11.
5Measure your heart rate, if desired.
See step 6 on page 12.
6 When the program has ended, remove the key.
Step onto the foot rails and make sure that the in-
cline | of the treadmill is at 1%. | The incline must | |
be at | 1% when the treadmill is raised to the |
| |
storage position. | Next, remove the key from the | ||
console and put it in a secure place. | Note: If the | ||
displays and indicators on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to page 21 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.
15