PART | R0902C |
To locate the parts listed below, refer to the EXPLODED DRAWING attached in the center of this manual.
Key No. | Qty. | Description |
| Key No. Qty. | Description |
|
1 | 2 | Foot Rail |
| 51 | 1 | Heart Rate Strap |
2 | 4 | Console Cover Screw | 52 | 2 | Roller Adj. Washer | |
3 | 1 | Audio Wire |
| 53 | 2 | Rear Roller Adjustment Bolt |
4 | 4 | Isolator |
| 54 | 1 | Left Rear Endcap |
5 | 1 | Latch Housing Cover | 55 | 1 | Frame | |
6 | 1 | Platform |
| 56 | 1 | Allen Wrench |
7 | 4 | Walking Platform Screw | 57 | 2 | Rear Platform Screw | |
8 | 1 | Walking Belt | 58 | 1 | Rear Roller | |
9 | 2 | Frame Pivot Bolt | 59* | 1 | Idler Assembly | |
10 | 4 | Frame Pivot Washer | 60 | 1 | Audio Wire Nut | |
11 | 1 | Front Wheel/Pulley | 61 | 1 | Pulse Bar | |
12 | 1 | Magnet |
| 62 | 1 | Left Foam Grip |
13 | 7 | Front Roller Nut/Front Wheel Nut | 63 | 1 | Idler Arm | |
14 | 2 | Spacer Insert | 64 | 1 | Idler Spring | |
15 | 2 | Frame Pivot Spacer | 65 | 1 | Upright | |
16 | 1 | Reed Switch Clip | 66 | 4 | Belt Guide Screw | |
17 | 1 | Reed Switch | 67 | 1 | Lock Knob | |
18 | 1 | Lift Frame | 68 | 1 | Latch Housing | |
19 | 2 | Foot Rail Insert | 69 | 1 | Lock Knob Spring | |
20 | 1 | Pulse Receiver Wire | 70 | 1 | Lock Pin Collar | |
21 | 20 | Foot Rail Screw | 71 | 1 | Pin Clip | |
22 | 1 | Motor Belt |
| 72 | 1 | Lock Pin |
23 | 1 | Pulse Receiver | 73 | 2 | Incline Pivot Bolt | |
24 | 1 | Motor |
| 74 | 1 | Flywheel |
25 | 1 | Transformer |
| 75 | 4 | Plastic Fastener |
26 | 2 | Small Upright Endcap | 76 | 2 | Handrail Extension | |
27 | 4 | Hood Bracket | 77 | 2 | Front Wheel | |
28 | 1 | Ground Wire | 78 | 2 | Wheel Bolt | |
29 | 4 | Star W | asher | 79 | 1 | Pulley Nut |
30 | 1 | Right Rear Endcap | 80 | 1 | Console | |
31 | 1 | Lift Motor Bolt | 81 | 1 | Console Cover | |
32 | 2 | Motor Bolt |
| 82 | 2 | Fan |
33 | 1 | Outlet Bracket | 83 | 2 | Right Pad | |
34 | 4 | Plastic | 84 | 8 | Belly Pan Screw | |
35 | 1 | Power Supply |
| 85 | 1 | Upright Wire Harness |
36 | 1 | Power Supply Bracket | 86 | 1 | Shock | |
37 | 1 | Controller |
| 87 | 2 | Large Upright Endcap |
38 | 1 | Controller Bracket | 88 | 2 | Left Pad | |
39 | 1 | Motor Hood |
| 89 | 1 | Filter Wire |
40 | 12 | 3/4” Screw |
| 90 | 1 | Latch Warning Decal |
41 | 1 | Motor Belly Pan | 91 | 1 | Incline Motor | |
42 | 2 | Belt Guide |
| 92 | 1 | Motor Controller Wire |
43 | 8 | 3/4” Tek Screw | 93 | 8 | Fan Screw | |
44 | 20 | Electronics Screw | 94 | 1 | Tie Holder Screw | |
45 | 1 | Left Front Endcap | 95 | 2 | Tie Holder | |
46 | 1 | Right Front Endcap | 96 | 1 | Tie | |
47 | 1 | Ground Screw | 97 | 5 | 8” Cable Tie | |
48 | 2 | Rear Foot |
| 98 | 2 | Bumper |
49 | 1 | Console Ground Wire | 99 | 1 | Idler Arm Bolt | |
50* | 1 | Motor Assembly | 100 | 1 | On/Off Switch |
30