If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the Speed or Incline buttons on
the console. However, when the next “chirp” is heard, the speed and/or incline will change to
the next settings of the CD or video program.
To stop the walking belt at any time, press a Stop button on the console. The Time/Segment Time display will begin to flash. To restart the program, press the Start button. After a moment, the walk-
ing belt will begin to move at 1.0 mph.When the next “chirp” is heard, the speed and incline
will change to the next settings of the CD or
video program . The program can also be stopped by pressing the stop button on your CD player or VCR.
When the CD or video program is completed, the
walking belt will stop and the Tim e/Segment Time display will begin to flash. Note: To use another
CD or video program, press a Stop button or re- move the key and go to step 1 on page 17.
Note: If the speed or incline of the treadmill does not change when a “chirp” is heard:
•Make sure that the iFIT.com indicator is lit and that the Time/Segment Time display is not flashing. If the Time/Segment Time display is flashing, press the Start button or the Speed
▲ button on the console.
• Adjust the volume of your CD player or VCR.
If the volume is too high or too low, the con- sole may not detect the program signals.
• Make sure that the audio cable is properly
| connected, that it is fully plugged in, and that |
| it is not wrapped around a power cord. |
| • If you are using your portable CD player and |
| the CD skips, set the CD player on the floor or |
| another flat surface instead of on the console. |
| Follow your progress with the four displays. |
5 | |
| See step 5 on page 11. |
| key.When the program is completed, remove the |
6 | |
| |
| See step 5 on page 12. |
CAUTION: Always remove iFIT.com CD’s and videocassettes from your CD player or VCR when you are finished using them.
18