Healthrider HCTL05910 manual Shifted to the left, Unplug Power Cord, Tion properly

PROBLEMSOLUTION

4.The walking belt is off-center or slips when walked on

a. Remove the key and		UNPLUG THE
POWER CORD. If the walking belt has
shifted to the left,		use the allen wrench to
turn the left rear roller bolt clockwise 1/2 of
a turn. Be careful not to overtighten the
walking belt.	If the walking belt has
shifted to the right,		turn the left rear roller

bolt counterclockwise 1/2 of a turn. Plug in the power cord, insert the key and run the

treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on,

b

first remove the key and

UNPLUG THE

POWER CORD

. Using the allen wrench,

turn both rear roller bolts clockwise 1/4 of a

turn. When the walking belt is correctly

tightened, you should be able to lift each

side of the walking belt 3 to 4 inches off the

walking platform. Be careful to keep the

walking belt centered. Plug in the power

cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat

until the walking belt is properly tightened.

5. The displays of the

a. Remove the key from the console and

UN-

console do not func-

PLUG THE POWER CORD.

Next, remove

a

1/8”

tion properly

the screws from the hood and carefully re-

11

move the hood. Locate the Reed Switch

20

(26) and the Magnet (85) on the left side of

26

85

the Pulley (11). Turn the Pulley until the

Magnet is aligned with the Reed Switch.

Top

Make sure that the gap between the

View

Magnet and the Reed Switch is about

3mm (1/8”)If. necessary, loosen the

Utility Screw (20) and move the Reed Switch slightly. Retighten the Screw. Re-at-

tach the hood, and run the treadmill for a few minutes to check for a correct speed

reading.

23