19.
Cable Assembly
IMPORTANT: Refer to the Cable Identification Chart on page 26 for help identifying the cables. Do not overtighten the bolts and nuts attaching the pulleys; the pulleys must be able to turn freely.
19 |
54 |
101 |
88 |
Locate the Press Cable (101). Route the eyelet end of the Cable through the indicated hole in the Press Upright (16).
Wrap the Press Cable (101) around a 115mm Pulley (54). Attach the Pulley inside the Press Upright (16) with an M10 x 65mm Bolt (88), two M10 Washers (89), two 15mm x 12mm Spacers (62), and an M10 Nylon Locknut (93).
20.Wrap the Press Cable (101) around a 115mm Pulley (54). Attach the Pulley and a Cable Trap (52) to the top set of holes in a pair of Pulley Plates (35) with an M10 x 50mm Bolt (77) and an M10 Nylon Locknut (93). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.
21.Route the Press Cable (101) over a 115mm Pulley (54) and through the Press Upright (16). Attach the Pulley inside the Press Upright with an M10 x 65mm Bolt (88), two M10 Washers (89), two 15mm x 12mm Spacers (62), and an M10 Nylon Locknut (93).
22.Wrap the Press Cable (101) around a 115mm Pulley (54). Attach the Pulley to the bracket on the Press Frame (12) with an M10 x 70mm Bolt (79). Make sure the Bolt is inserted from the indicated side. Do not thread a locknut onto the Bolt yet.
12
93 | 62 | |
89 | ||
89 | ||
62 | ||
| 16 | |
20 |
| |
| 101 | |
93 | 52 | |
| 77 | |
35 | ||
| 54 | |
| 35 | |
21 |
| |
89 62 |
| |
93 |
| |
| 101 | |
| 89 | |
| 62 | |
54 | 88 | |
| ||
16 | ||
22 |
| |
12 | Bracket | |
| ||
79 |
| |
101 |
| |
54 |
| |