NordicTrack NTSY59210 Adjustments, Adjusting the Press ARM, Changing the Weight Setting

Page 22

ADJUSTMENTS

This section explains how to adjust the weight system. See the EXERCISE GUIDELINES on page 28 for impor- tant information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise guide to see the correct form for each exercise.

Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi- ately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ADJUSTING THE PRESS ARM

To adjust the Arms (8, 9), pull the Knob w/Threads

(106)out as far as it will go. Rotate the Press Bracket

(10)to the desired position and engage the Pin into an adjustment hole.

WARNING: Make sure the Knob w/Threads (106) is fully engaged into the Press Bracket (10) before exercising.

ATTACHING THE AB STRAP OR LAT BAR TO THE HIGH OR LOW PULLEY STATION

Attach the Ab Strap (21) to the High Cable (100) with a Cable Clip (91). For some exercises, the Chain (94) should be attached between the Ab Strap and the Cable with two Cable Clips. Adjust the length of the

Chain between the Ab Strap and the Cable so the Ab Strap is in the correct starting position for the exercise to be performed.

The Lat Bar (not shown) can be attached to the High Cable (100) in the same manner. The Ab Strap can be attached to the Press Cable (not shown) in the same manner.

CHANGING THE WEIGHT SETTING

To change the weight setting of the weight stack, insert the Weight Pin (30) under the desired Weight (29, 34). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The weight setting of the weight stack can be changed from 5 pounds to

200 pounds, in increments of 5 and 10 pounds. Note:

Due to the cables and pulleys, the actual amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 24 to find the actu- al amount of resistance at each weight station.

106

 

 

Adjustment

 

 

Hole

 

 

9

 

 

10

8

 

 

 

100

 

 

91

91

 

 

 

 

94

21

 

 

 

 

34

 

30

29

22

 

 

Image 22
Contents Model No. NTSY59210 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions DecalBefore YOU Begin Assembly Make Assembly Easier for YourselfFrame Assembly Do not tighten the M10 Nylon Locknuts 93 yet Locknuts yet Tighten the M10 Nylon Locknuts 93 used in steps Arm Assembly Page Cable Assembly Page Page Page Page Page Page Seat Assembly Bracket will be closer to the rear edge of the Seat Page Adjusting the Press ARM AdjustmentsChanging the Weight Setting Adjusting the Seat Adjusting the BackrestWeight Resistance Chart Weight Press Butterfly LEG High LOW Plates ARM Lever PulleyTroubleshooting and Maintenance Tightening the CablesHigh Cable Cable DiagramsPress Cable Cable Identification Chart Butterfly CableRear Cable Exercise Guidelines Cooling Down Muscle ChartStaying Motivated Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateMonday Part Identification CHART-Model No. NTSY59210 R0303APage 50mm Square Inner Cap Part LIST-Model No. NTSY59210 Qty DescriptionExploded Ordering Replacement Parts Limited Warranty