39.Wrap the Butterfly Cable (102) around a 115mm Pulley (54). Attach the Pulley and a Cable Trap
(52)to the bracket on the Press Base (1) with an
M10 x 45mm Bolt (86) and an M10 Nylon Locknut
(93).Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.
40.Attach the end of the Butterfly Cable (102) to the Right Butterfly Arm (7) with an M10 x 40mm Bolt (83), a 15mm x 12mm Spacer (62), an M10 Washer (89), and an M10 Nylon Locknut (93).
Make sure the Spacer is inside the loop in the Cable.
41.Locate the Rear Cable (103). Wrap the Cable under a 115mm Pulley (54). Attach the Pulley to the indicated bracket on the Rear Base (2) with an M10 x 45mm Bolt (86) and an M10 Nylon Locknut (93).
42.Wrap the Rear Cable (103) around a 115mm Pulley (54). Attach the Pulley to the indicated bracket on the Press Base (1) with an M10 x 45mm Bolt (86) and an M10 Nylon Locknut (93).
39 |
|
|
|
| 86 |
| 52 |
|
|
| |
| 54 |
|
|
|
|
| 93 |
|
|
| 1 |
|
|
| 102 |
40 |
|
|
|
|
| 7 |
|
83 | 102 | 93 |
|
89 |
|
|
|
| 62 |
|
|
41 |
|
|
|
|
|
| 54 |
|
|
| 86 |
|
|
| 103 |
|
| 93 | 2 |
42 |
|
|
|
|
| 54 | 86 |
| 103 |
| 1 |
| 93 |
|
|
17