NordicTrack NTSY59210 user manual Seat Assembly

47.Slide the tether on the Weight Pin (30) onto the tube on the Top Weight (32). Rest the M12 Washer (76) on the tube.

Thread the M12 Nut (96) onto the bolt on the end of the Rear Cable (103). Thread the bolt into the tube in the Top Weight (32) until there is no slack in the Cable.

Tighten the M12 Nut (96) against the M12 Washer (76).

Note: If you have purchased the hack squat extension (model NTSY3921), complete steps 9–16 in the NTSY3921 manual.

Seat Assembly

48.Attach the Shroud (18) to the two M8 x 90mm Bolts (90) in the Rear Top Frame (19) with two M8 Nylon Locknuts (75).

Tighten the two M8 x 90mm Bolts (90) in the Rear Base (2) into the Shroud (18).

49.Press two 25mm Round Inner Cap (55) into the ends of the Long Pad Tube (37).

Center the Long Pad Tube (37) in the tube on the Press Upright (16). Tighten the M6 x 20mm Self- tapping Screw (63) into the Pad Tube.

Slide two Foam Pads w/Large Holes (108) onto the ends of the Long Pad Tube (37).

47
103	96
30	76
Tube	32
48
	90	19
	75
18		2
	90
49
	16
108	Tube
55	63
37
55		108

19