Cateye EC-C400 instruction manual Troubleshooting

Page 49

3 TROUBLESHOOTING

Troubleshooting

In the following cases, the machine is not broken. Be sure to check the following before asking for the machine to be serviced.

			Problem	Item to check	Countermeasure
	Display does not appear.			Is the power supply connected?	Connect the AC adaptor correctly.
					(see page 13)

				Is the power switch on?	Turn the power on. (see page 13)

				Isn't the cable of the AC Adapter dam-	Replace the AC Adapter if its interior
				aged?	circuit or the cable is damaged.
					Use only CATEYE AC Adapter.

	ERROR or irregular display appears			Isn't the data card reversed?	Hold the card yellow arrow side up,
	when you insert the data card.				and insert to the direction of arrow.

				Didn't you insert the card too quickly?	Insert the card slowly.

				Didn't you specify two or more pro-	Refer to P.42~43 and specify the pro-
				grams, or open unnecessary holes?	gram and conditions correctly.

	When the pulse (earlobe) sensor is			Is the earlobe sensor attached correctly	Attach the sensor correctly to your ear-
	used, the pulse rate displayed on the			to your earlobe?	lobe and take care not to swing the sen-
	control unit remains at “0”.				sor or sensor cable during the exercise.
	control unit remains at “0”.			Is the sensor plug completely inserted	sor or sensor cable during the exercise.
	The pulse rate increases abnormally.			Is the sensor plug completely inserted	If the sensor cable proves to be dam-
	The pulse rate increases abnormally.			into the sensor jack?	If the sensor cable proves to be dam-
				into the sensor jack?	aged, replace the whole pulse sensor

				Isn't the sensor cable damaged?
				Isn't the sensor cable damaged?	with a new one.
					with a new one.
	When the chest-belt sensor is used, the			Is the earlobe sensor plug connected to	When the earlobe sensor is connected,
	pulse rate displayed on the control unit			the control unit?	signals from the chest-belt sensor are
	remains at “0”.				not received. Remove the earlobe sen-
					sor plug from the control unit.

				Is the chest belt attached correctly?	Attach the chest belt correctly accord-
					ing to the procedure.

				Is the chest belt loose?	Attach the chest belt with the electrode
					area making contact with your body.

				Is the air dry? (especially in winter)	Slightly dampen the electrode area of
					the chest belt.

				Has the electrode belt deteriorated or	Replace it with a new electrode belt.
				has it become worn or damaged due to
				long-term use?

				Is the battery low?	Replace it with a new battery.

	When the chest-belt sensor is used, the			Is the chest belt attached correctly?	Attach the chest belt correctly accord-
	pulse rate displayed on the control unit				ing to the procedure.
	indicates “0” or measurement starts.
	indicates “0” or measurement starts.			Does the pulse rate indicate “0” at a	The battery is low. Replace it with a
				Does the pulse rate indicate “0” at a	The battery is low. Replace it with a
				distance from the control unit and does	new battery. If the problem persists,
				measurement start when closer to the	check the receiving board in the con-
				unit?	trol unit.

	The evaluation of fitness level seems			Is the weight unit correct?	Set the weight unit correctly. (see page
	incorrect.				48)

	The exercise program indicates “STOP			Does a buzzer sound because your pulse	Set your age properly so that the alarm
	EXERCISE” and ends prematurely.			rate exceeds the upper pulse limit speci-	does not sound.
				fied in the program?

	Clattering noise is heard with the			Are the pedals firmly attached to the	Attach the pedals firmly.
	pedal rotation.			crank? If not, noise may be produced.

49

Image 49

Contents UPRIGHTEC-C4OOBIKE Contents HOW to USE this ManualIntroduction Main body Control unit Part NamesLCD Start Guide Starting with Assembly Attach the rear leg Attach the front legMount the handlebar post Mount the saddleAttach the pedals Install the control unitAdjust the saddle height 2HOW to Adjust Each PartAdjust the handlebar height Adjust the handlebar angleAdjust the saddle angle Connect the pulse sensor Adapting the Pulse SensorHandling of sensor cable Use pulse earlobe sensor during exerciseTrying OUT the EC-C400FOR the First Time Turn on power and attach earlobe sensorInsert the start card the red card provided Check the screen displayLCD Press the Start button to startFinish your training Bring up the calories display by pressing Mode buttonFitness Test physical fitness test 6 Kinds of ProgramsHR control training training at a constant pulse rate Hill training training by cycling up mountainsQuick start training at any desired pedal resistance Interval training exercise + relief periodsTurn on the power supply Using the EC-C400WITHOUT a Data CardSelect a training program Input training conditions Finish your exercise Start your exerciseCheck your exercise record by scrolling the screen Operation Guide Page Training goals 1TRAINING GoalsDifference between heart rate and pulse rate Maximum Heart RatePulse Limit Target Pulse RateHR control training 2YOUR Strength Level and Training IndexConstant wattage control training Hill trainingQuick start training Interval trainingSelect the Fitness test program 3FITNESS TestInput the conditions Start the programFinish the Fitness test Test result display and cool downEnd the program Physical Fitness Level PFL 4FITNESS TestMaximum Oxygen Uptake MOU Maximum Physical Work Capacity PWC maxMale≥ Test ProtocolSelect the HR control training program 5HR Control TrainingStart the warm-up Finish your exercise Continue the training, maintaining the target pulseSelect the Constant wattage control training program 6CONSTANT Wattage Control TrainingIbly, and the pedal resistance drops to the minimum Continue the training, maintaining the wattageSelect the Hill training program 7HILL TrainingInput training conditions Start the trainingContinue the training Select the Interval training program 8INTERVAL TrainingContinue the training by repeating exercise and rest Select the Quick start program 9QUICK StartCool-down display or the end display Specify program 10HOW to Make a Data CardSpecify age Specify exercise timeSample data cards Specify training targetReference Guide Page CHEST-BELT Heart Rate Sensor Use the wireless chest-belt heart rate sensorFunction of the chest-belt heart rate sensor Before putting on the chest-belt heart rate sensorReplace the electrode belt Replace the batteryOther Useful Functions Change the units of weightChange the units of resistance of pedaling Troubleshooting TroubleshootingAbout the repair service warranty Daily Maintenance Repair Service WARRANTY/ADDITIONAL PartsAccessories/Consumable Parts Additional PartsProduct Specifications 066660051 E