Healthrider WESY8630C3 manual Nylon Locknut, As shown, Shown

FRAME ASSEMBLY

ARM ASSEMBLY

11. Attach the Leg Press Plate (11) to the

Adjustment Tube (10) with a 5/16” x 2 1/2” Bolt (39), two 5/16” Washers (20), and a 5/16”

Nylon Locknut (40).		Be sure that the Leg
Press	Plate and Adjustment Tube are ori-
ented	as shown.

Press a 1 3/4” Square Inner Cap (48) into the

Adjustment Tube (10).

12. Attach the Adjustment Tube (10) to the Leg
Press Arm (9) with the Lock Pin (73).	Be sure
the Leg Press Plate (11) is oriented as
shown.
Press two 2” Square Inner Caps (56) into the
Leg Press Arm (9).

13.Locate and open the parts bag labeled “ARM ASSEMBLY.”

Attach the Leg Press Bumper (53) to the

Front Seat Frame (8) with the 1” Tap Screw (72).

Lubricate the 3/8” x 3 1/4” Bolt (71). Attach the Leg Press Arm (9) to the Press Base (13)

with the Bolt and a 3/8” Nylon Locknut (42).

14.Press a 1” x 7/8” Plastic Bushing (54) onto

each welded spacer on the Press Frame (12). Slide the Press Frame onto the Press Base

(13) so that the Plastic Bushings are aligned

with the indicated tube. Note: This will be a

tight fit. Make sure that the high pulley is on the side shown.

Lubricate the 3/8” x 8” Bolt (52). Attach the Press Frame (12) to the Press Base (13) with

the Bolt and a 3/8” Nylon Locknut (42).

9

11
		10
		40
48		20
39
		Angle
		11
12		10
	73
		11
		9
		56
13
		8
		9
		53
		42
		72
		71—Lubricate
		13
14
		Tube
High		12
Pulley
Welded		13
Spacers		52—Lubricate
	42	54