Suunto t3 manual Autolap settings, Speed settings, Calibrate settings

Page 26

Long press the ENTER button in Speed and

2 sec Distance mode to enter Speed and Distance settings menu.

Use UP and DOWN buttons to toggle between the following Speed and Distance setting submenus: autolap, speed, calibrate, pair a POD and general.

Autolap settings

In the Autolap menu, you can set the autolap function on or off and set the distance for each lap. When autolap is set on, and you have a paired speed and distance POD, the device beeps and shows total distance, average lap speed, and lap time for 5 seconds with each lap.

Speed settings

In the Speed menu, you can set the speed limit on or off and define the upper and lower speed limits.

Calibrate settings

In the Calibrate menu, you can calibrate your Suunto Foot POD or Suunto Bike POD. An alternative way of calibrating your POD is to run or cycle a known distance, say 10 km, using the POD. If you do not reset the stopwatch after completing the distance, you can correct the distance shown, for example 9.6 km, from the settings. The device will then update the calibration value accordingly. The GPS POD is also listed in the Calibrate menu but the calibration has no effect on the GPS POD measurements. You will need this calibration only if you have, for instance, two Bike PODs for different bikes. You can then pair one of them as GPS POD and use the calibration in the same way as you normally would with Bike POD.

24

Image 26 Suunto t3 manual Autolap settings, Speed settings, Calibrate settings
Contents Page Time mode Training / Speed Distance mode Welcome Page Page Getting Started Setting up Suunto t3 Activity class act classActivity description Mode if paired with POD Suunto t3 at a glanceSuunto software are required Totals Logbook Settings menu Time modeAlarm snooze LightTraining mode Light Change Training Effect Target Long PressSpeed and Distance mode SettingsTime mode settings Symbol Setting OptionsTraining mode settings PODSpeed and Distance mode settings Before Training Heart rate signal troubleshooting Wireless speed and distance PODs Time mode settingsDate settings Alarm settingsTime settings Personal settingsHeart rate zone settings General settingsTraining mode settings Sports Medicine for exercise prescription Heart rate limit settings Target heart rateSpeed and Distance mode settings Intervals settingsPair a POD settings Calibrate settings Autolap settingsSpeed settings Training Effect Measured TE Description Result of the workoutPage Training Using Training Effect targets Training without set targetsPage Using the speed and distance displays After Training Training LogbookTraining Totals Page General instructions Care and MaintenanceSuunto Training World Water resistance Changing the strap lengthReplacing the battery Replacing the battery of the Suunto t3 Page Technical Specifications GeneralIntellectual Property CopyrightPatent notice DisclaimersTrademark Users responsibilityIces Limits of liability and ISO 9001 complianceAfter sales service FCC compliance Disposal of the Device Page TWO Year Warranty Store City Customer Service Contacts CopyrightSuunto Oy 5/2006