INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
A S S E M B LY STEP 3 |
|
|
|
| UPPER HANDLEBAR |
| NOTCH |
|
CONSOLE MAST |
| |
| SET SCREWS | |
| TAB | |
USE LEFT HANDLEBARS | USE RIGHT HANDLEBARS | |
|
| |
|
| BOLT & WASHER |
|
| LOWER HANDLEBAR |
NOTE: There is NO hardware bag for this step. All hardware is
A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by
C)Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using
Reminder: The upper and lower handlebars are marked with an L if they are to be used on the
|
| After handlebars are assembled they will rotate freely – be cautious. Until the |
| WARNING | |
| machine is fully assembled, do not grab the handlebars for support. | |
|
|
|
|
|
|
LIMITED WARRANTY
10