Trek 11i, 9i To set the odometer, MH and KMH interchange on the screen, Temperature icon display

Page 15

3.Cycle Mode

MH and KMH interchange on the screen.

4. Push Set• to select.

The temperature icon display.

5.Cycle Mode to C or F

6.Push Set• to select.

The computer returns to the start screen.

ODO	Set
TME
AVG
MAX
TRP

Mode

FMPH

CLKTMEODOMAXTRPAVG

To set the odometer

Figure 13- ODO screen

1.Cycle Mode to ODO (Figure 13).

2.Hold Set•

5-digit odometer value appears with first digit flashing.

3.Cycle Mode to your preferred value.

4.Push Set• to select.

The next digit flashes.

5.Repeat steps 3 and 4 until all digits are selected.

The computer returns to the start screen.

Easy setup (ReSet)

13

Image 15

Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsCAD Installation Stem mount Handlebar Speed sensorMount 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Mode Using the buttonsTo set the units SetComputer returns to the start screen Temperature icon displayTo set the odometer MH and KMH interchange on the screenWheel size changes To set wheel sizeWheel Select icon appears on the screen Wheel size appearsTo select the wheel for use Cycle Mode to TRPHour changes To set Clock12 or 24 flashes 24 interchange on the screenTo ReStart set the Trip data to zero Max setting ReStarts at ‘0’Removing the computer from the computer base Changing modeUsing the computer in wet weather Additional informationTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the BatterySetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover