Trek 11i, 9i owner manual Troubleshooting

Page 21

Troubleshooting

The Incite 9i computer is designed to be easy to install and maintain. However, computers occasionally have problems. Table 3 shows some possible problems, causes, and solutions:

Table 3- Common problems and solutions

Blank screen	Computer is in shipping mode. Push a button.

	Battery is dead, or installed incorrectly. Reinstall good battery.

Erratic data	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

	Battery power is low. Replace battery.

No current speed	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

Speed is incorrect.	Wheel size is incorrect. Reset computer.

	Sensor is not reading magnet properly. Readjust magnet and sensor alignment.

Troubleshooting 19

Image 21

Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsCAD Installation Stem mount Handlebar Speed sensorMount 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet To set the units Using the buttonsSet ModeTo set the odometer Temperature icon displayMH and KMH interchange on the screen Computer returns to the start screenWheel Select icon appears on the screen To set wheel sizeWheel size appears Wheel size changesTo select the wheel for use Cycle Mode to TRP12 or 24 flashes To set Clock24 interchange on the screen Hour changesTo ReStart set the Trip data to zero Max setting ReStarts at ‘0’Using the computer in wet weather Changing modeAdditional information Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the BatterySetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover