Trek 11i, 9i owner manual Limited Warranty, This warranty covers, This warranty does not cover

Page 27

Limited Warranty

Trek Bicycle Corporation warrants each new Incite computer against defects in workmanship and materials.

This warranty covers

Trek Incite computer models 6i, 8i, 9i, 11i, ACH, and ACH Digital for a period of two years from the date of sale.

This warranty does not cover

Normal wear and tear, including the length of battery life

Improper assembly

Installation of parts or accessories not originally intended for, or compatible with the component as sold

Damage or failure due to accident, misuse, abuse, or neglect

This warranty is void in its entirety by any modification of the

component or its parts.

This warranty is expressly limited to the repair or replacement of a defective item and is the sole remedy of the warranty. This warranty extends from the date of purchase, applies only to the original owner, and is not transferable. Trek is not responsible for incidental or consequen- tial damages. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you.

Claims under this warranty must be made through an authorized dealer. Proof of purchase is required.

This warranty gives the consumer specific legal rights, and those rights may vary from place to place. This warranty does not affect the statutory rights of the consumer.

Limited Warranty

25

Image 27
Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsCAD Installation Stem mount Handlebar Speed sensorMount 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Mode Using the buttonsTo set the units SetComputer returns to the start screen Temperature icon displayTo set the odometer MH and KMH interchange on the screenWheel size changes To set wheel sizeWheel Select icon appears on the screen Wheel size appearsTo select the wheel for use Cycle Mode to TRPHour changes To set Clock12 or 24 flashes 24 interchange on the screenTo ReStart set the Trip data to zero Max setting ReStarts at ‘0’Removing the computer from the computer base Changing modeUsing the computer in wet weather Additional informationTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the BatterySetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover