Trek 9i, 11i owner manual Using the buttons, To set the units, Set, Mode, KMH or MH flashes

Page 14

Using the buttons

When setting the computer, there are three ways to use the buttons. To help you remember, notice the way

F	MPH	each term is underlined. To help you
CLKTMEAVGMAXTRPAVG		remember, these terms will look the
	Set	same throughout the manual.
		Push- touch once
		Cycle - push repeatedly as needed
		Hold- push and hold in for two or
Mode		three seconds
Figure 12- Buttons on the Incite		The buttons on the computer are
9i and 11i computer		(Figure 12):

Set• button on the right side

Mode button on the bottom

To set the computer, you must Push, Cycle, or Hold the two buttons in a specific sequence.

To set the units

1.Cycle Mode to MAX (Figure 12).

2.Hold Set•

KMH or MH flashes.

12 Easy setup (ReSet)

Image 14

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Mount InstallationStem mount Handlebar Speed sensor To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wire0mm To install the sensorSensor can be rotated around the fork about 45 degrees Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set the units ModeMH and KMH interchange on the screen Temperature icon displayTo set the odometer Computer returns to the start screenWheel size appears To set wheel sizeWheel Select icon appears on the screen Wheel size changesCycle Mode to TRP To select the wheel for use24 interchange on the screen To set Clock12 or 24 flashes Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroAdditional information Changing modeUsing the computer in wet weather Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealTo set the computer Setting custom wheel sizeSelecting the custom value 4-digit number Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeThis warranty does not cover Limited WarrantyThis warranty covers

Using the buttons

Set

Mode

Figure 12- Buttons on the Incite

To set the units

KMH or MH flashes.