Trek 9i, 11i owner manual Tighten the nylon ties and trim the excess length Figure

Page 12

and magnet by spinning the wheel and noting if the computer is displaying speed.

If the computer shows current speed, the sensor is reading the magnet.

If the computer is not displaying a value, realign the sensor and magnet until one is displayed.

5.Tighten the nylon ties and trim the excess length (Figure 11).

Figure 11- Trim excess nylon tie length

10 Installation

Image 12

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Installation Stem mount Handlebar Speed sensorMount To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced off To install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons To set the unitsSet ModeTemperature icon display To set the odometerMH and KMH interchange on the screen Computer returns to the start screenTo set wheel size Wheel Select icon appears on the screenWheel size appears Wheel size changesCycle Mode to TRP To select the wheel for useTo set Clock 12 or 24 flashes24 interchange on the screen Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroChanging mode Using the computer in wet weatherAdditional information Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealSetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover