Trek 11i, 9i owner manual To ReStart set the Trip data to zero, Max setting ReStarts at ‘0’

Page 19

ODO	Set
TME
AVG
MAX
TRP

Mode

ReStart- Getting ready to ride

Your computer stores data for two intervals- since last ReSet and since last ReStart. ReSet sets ALL data to zero. ReStart sets only the Trip data to zero.

The trip modes include

•TRP

•TME

•MAX

This operation sets all four values to zero, allowing the computer to display information for a single ride.

To ReStart (set the Trip data to zero)

1.Cycle Mode to TRP (Figure 16).

2.Hold Set•, and do not let up until after completing step 3.

3.Hold Mode.

The Max setting ReStarts at ‘0’.

FMPH

CLKTMEAVGMAXTRPAVG

Figure 16- TRP screen

ReStart 17

Image 19

Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsCAD Stem mount Handlebar Speed sensor InstallationMount 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireSensor can be rotated around the fork about 45 degrees To install the sensor0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Mode Using the buttonsTo set the units SetComputer returns to the start screen Temperature icon displayTo set the odometer MH and KMH interchange on the screenWheel size changes To set wheel sizeWheel Select icon appears on the screen Wheel size appearsTo select the wheel for use Cycle Mode to TRPHour changes To set Clock12 or 24 flashes 24 interchange on the screenTo ReStart set the Trip data to zero Max setting ReStarts at ‘0’Removing the computer from the computer base Changing modeUsing the computer in wet weather Additional informationTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the BatterySelecting the custom value 4-digit number Setting custom wheel sizeTo set the computer Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel sizeThis warranty covers Limited WarrantyThis warranty does not cover