Trek 9i, 11i Additional information, Changing mode, Removing the computer from the computer base

Page 20

ODO	Set
TME
AVG
MAX
TRP

Mode

Additional information

Changing mode

Once the computer is programmed and installed, it is very easy to use. To change to different modes (functions), simply Cycle the Mode button until the desired function appears, shown by the spelled name of the function.

Removing the computer from the computer base

The computer is held on its base by a flexible snap. To remove the computer, press firmly on the computer (not on the base) in a rearward direction.

Using the computer in wet weather

Bicycle computers function on electricity. If the electrical contacts between the computer and its base become saturated, the electrical signals may become irregular or interrupted entirely. If the computer is to be used in heavy rain, etc., we recommend that a plastic bag be put over the computer and its base. The other parts of the computer system are waterproof.

18 Additional Information

Image 20

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Mount InstallationStem mount Handlebar Speed sensor To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wire0mm To install the sensorSensor can be rotated around the fork about 45 degrees Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons To set the unitsSet ModeTemperature icon display To set the odometerMH and KMH interchange on the screen Computer returns to the start screenTo set wheel size Wheel Select icon appears on the screenWheel size appears Wheel size changesCycle Mode to TRP To select the wheel for useTo set Clock 12 or 24 flashes24 interchange on the screen Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroChanging mode Using the computer in wet weatherAdditional information Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealTo set the computer Setting custom wheel sizeSelecting the custom value 4-digit number Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeThis warranty does not cover Limited WarrantyThis warranty covers