Trek 9i, 11i To set wheel size, Wheel Select icon appears on the screen, Wheel size appears

Page 16

ODO	Set
TME
AVG
MAX
TRP

Mode

To set wheel size

Both the 9i and 11i allow you to use two different wheel sizes. The icon for Wheel 1 is a small circle. The icon for Wheel 2 is a partial circle surrounding the Wheel 1 icon (Figure 14).

1.Cycle Mode to TME.

2.Hold Set•

Wheel Select icon appears on the screen.

3.Cycle Set• to change wheel selection from Wheel 1 to Wheel 2.

4.Push Mode to select.

Wheel size appears.

Note: If you want to set a custom wheel size, go to page 24 now.

Figure 14- Wheel select screen

5.Cycle Mode

The wheel size changes.

6. Hold Set• to select.

The computer returns to current speed.

To set the second wheel size, repeat the instructions, but select the other Wheel Select icon.

14 Easy setup (ReSet)

Image 16

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Stem mount Handlebar Speed sensor InstallationMount To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireSensor can be rotated around the fork about 45 degrees To install the sensor0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons To set the unitsSet ModeTemperature icon display To set the odometerMH and KMH interchange on the screen Computer returns to the start screenTo set wheel size Wheel Select icon appears on the screenWheel size appears Wheel size changesCycle Mode to TRP To select the wheel for useTo set Clock 12 or 24 flashes24 interchange on the screen Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroChanging mode Using the computer in wet weatherAdditional information Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealSelecting the custom value 4-digit number Setting custom wheel sizeTo set the computer Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeThis warranty covers Limited WarrantyThis warranty does not cover