Trek 9i Setting custom wheel size, Selecting the custom value 4-digit number, To set the computer

Page 24

ODO	Set
TME
AVG
MAX
TRP

Mode

Setting custom wheel size

The procedure is almost the same as the basic setup on pages 13-14, except instead of picking a wheel size from the menu, you can program in a 4-digit number.

Selecting the custom value 4-digit number

There are two methods for selecting the custom wheel size value:

•Select a value from Table 3, Custom wheel size codes

•Do a rollout test to measure the circumference of your wheel (page 24).

To set the computer

1. Cycle Mode to TME.

Table 3- Custom wheel size codes

700 x 20	2086	26 x 1.5	2010

700 x 23	2096	26 x 1.90	2045

700 x 25	2105	26 x 1.95	2050

700 x 28	2136	26 x 2.0	2055

700 x 32	2155	26 x 2.1	2068

700 x 35	2168	26 x 2.2	2075

700 x 38	2180	Custom
		0000 - 2999

2.Hold Set•

Wheel Select icon appears on the screen.

3.Cycle Set• to change your wheel selection from Wheel 1 to Wheel 2.

22 Setting Custom Wheel Size

Image 24

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Installation Stem mount Handlebar Speed sensorMount To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons To set the unitsSet ModeTemperature icon display To set the odometerMH and KMH interchange on the screen Computer returns to the start screenTo set wheel size Wheel Select icon appears on the screenWheel size appears Wheel size changesCycle Mode to TRP To select the wheel for useTo set Clock 12 or 24 flashes24 interchange on the screen Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroChanging mode Using the computer in wet weatherAdditional information Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealSetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover