Trek 9i, 11i owner manual Installation, Stem mount Handlebar Speed sensor, Mount

Page 6

Installation

Stem mount

Handlebar	Speed sensor	Cadence sensor
mount

Figure 3- Location on bicycle of sensors and computer

Tools needed:

•Electrical tape

•Slot-type screwdriver

•Phillips-type screwdriver

•Scissors

Installation

Image 6

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Installation Stem mount Handlebar Speed sensorMount To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Sensor can be rotated around the fork about 45 degrees0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set the units ModeMH and KMH interchange on the screen Temperature icon displayTo set the odometer Computer returns to the start screenWheel size appears To set wheel sizeWheel Select icon appears on the screen Wheel size changesCycle Mode to TRP To select the wheel for use24 interchange on the screen To set Clock12 or 24 flashes Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroAdditional information Changing modeUsing the computer in wet weather Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealSetting custom wheel size Selecting the custom value 4-digit numberTo set the computer Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover