Trek 11i, 9i owner manual To select the wheel for use, Cycle Mode to TRP

Page 17

ODO	Set
TME
AVG
MAX
TRP

Mode

To select the wheel for use

1.Cycle Mode to TRP

2.Hold the left Mode and the right Mode together.

The Wheel Select icon changes (Figure 14). Repeat step 2 to change again.

Easy setup (ReSet)

15

Image 17

Contents Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsCAD Mount InstallationStem mount Handlebar Speed sensor 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wire0mm To install the sensorSensor can be rotated around the fork about 45 degrees Tighten the nylon ties and trim the excess length Figure Easy setup ReSet To set the units Using the buttonsSet ModeTo set the odometer Temperature icon displayMH and KMH interchange on the screen Computer returns to the start screenWheel Select icon appears on the screen To set wheel sizeWheel size appears Wheel size changesTo select the wheel for use Cycle Mode to TRP12 or 24 flashes To set Clock24 interchange on the screen Hour changesTo ReStart set the Trip data to zero Max setting ReStarts at ‘0’Using the computer in wet weather Changing modeAdditional information Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the BatteryTo set the computer Setting custom wheel sizeSelecting the custom value 4-digit number Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel sizeThis warranty does not cover Limited WarrantyThis warranty covers