Trek 9i, 11i owner manual Replacing the battery, To replace the battery

Page 22

Replacing the battery

If the computer is giving erratic information, the computer or hear rate strap battery may be running low on power (normally accompanied by the low battery icon, Figure 16). Replace the batteries whenever the computer malfunctions, or every 6 months. When purchasing new batteries, it is best to take the old batteries with you. However, this is the generic description for the proper battery:

CR2032, lithium cell, 3 volts

When the battery is removed, the computer automatically resets function totals to Zero. After installing a new battery, you can manually set your totals, but you must note those values

before removing the battery.

To replace the battery

1. Remove the computer from its base.

2.Identify the battery cover, with its deep slot (a similar battery cover is found on the back, or skin-side, or the heart rate strap).

3.Insert a large coin into the slot and rotate in a counter-clockwise direction about

Figure 17- Removing		battery	one-quarter turn (Figure 17).
cover
20	Replacing the Battery

Image 22

Contents Trek Incite 9i Copyright Trek Bicycle Corporation 2006 All rights reservedContents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationCAD Stem mount Handlebar Speed sensor InstallationMount To install the computer on handlebar 31.8mm bars large clamp 25.4mm and 26.0mm small clampTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireSensor can be rotated around the fork about 45 degrees To install the sensor0mm Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set the units ModeMH and KMH interchange on the screen Temperature icon displayTo set the odometer Computer returns to the start screenWheel size appears To set wheel sizeWheel Select icon appears on the screen Wheel size changesCycle Mode to TRP To select the wheel for use24 interchange on the screen To set Clock12 or 24 flashes Hour changesMax setting ReStarts at ‘0’ To ReStart set the Trip data to zeroAdditional information Changing modeUsing the computer in wet weather Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the battery‘cross’ on the bat- tery points up Replacing the Battery Be careful to avoid losing the rubber O-ring sealSelecting the custom value 4-digit number Setting custom wheel sizeTo set the computer Left-hand digit flashes To measure rollout for wheel size Measuring rollout for wheel sizeThis warranty covers Limited WarrantyThis warranty does not cover