Precor C932 owner manual Follow steps 9a. through 9d. on the opposite side

C O M M E R C I A L P R O D U C T S D I V I S I O N

11.Install the center handrail. Loosen the four fasteners in the handrail clamp bracket with the hex key provided. See Diagram 9, #1.The center handrail is packaged in two pieces. Install one side at a time by following these steps:

a.Insert a handrail end cap. See Diagram 9, #2.

b.Slide the end of the handrail into the center clamp and rotate the handrail so that it falls inside the end cap. See Diagram 9, #3.

Diagram 10 Secure the display	2
console and center
handrail.
Center handrail
mounting bracket
(right side)	1
1-inchscrews (G)
with washers (D)
(right side)
Handrail end cap
screw (C) with
washer (F)
(left side)
3	4

c.Align the center handrail’s mounting bracket with the holes in the upright support. See Diagram 10, #1. Insert two 1-inch screws (G) with washers

(D) and finger tighten. See Diagram 10, #2. Do not securely tighten the screws until both sides of the center handrail have been attached. See Diagram 10, #1 and #2.

d.Align the mounting holes in the handrail with the end cap. Place a washer (F) on screw (C) and insert the screw. Finger tighten. See Diagram 10, #4.

e.Follow steps 9a. through 9d. on the opposite side.

page 15