Precor C932 owner manual Quick Steps to Working OUT, Straddle belt

Page 37

C O M M E R C I A L P R O D U C T S D I V I S I O N

QUICK STEPS TO WORKING OUT

When you first turn the unit ON, the PRECOR banner scrolls across the display. This banner indicates that the C932 is ready to accept user entries.

1Put on the chest strap.

(Part of the Precor Heart Rate Option.)

2Straddle belt.

1.To use the heart rate capabilities in the C932 treadmill, you need to wear a POLAR® chest strap during your workout.

2.Make sure that the PRECOR banner scrolls across the display. Straddle the running belt with your feet firmly planted on the right and left staging platforms. Stand close enough to the display console so that you can extend your arms and touch the keys.

3Attach security clip to clothing.

4Face the display and select a course.

5Begin working out.

Note: Any time during the Setup prompts, you can press the QuickStart key. Refer to QUICKSTART on page 33.

3.Attach the security clip to your clothing near your waistline.

4.Face the display and hold onto the handrail with one hand when you press the keypad with the other. There are sev- eral different paths you can take to move through the Setup mode. How you set up your workout depends on how de- tailed you like to be.

While the PRECOR banner scrolls, do one of the following:

•Press SELECT — By pressing SELECT, the MANL (Manual) course selection appears. To select a different course, use the ▼▲ keys. When your preferred course ap- pears, press SELECT. If the course selection lets you des- ignate a workout time, the XX MIN (time prompt) appears. Use the ▼▲ keys to select a time between NOLIM (zero - no time limit) and 99 minutes.

Note:The club has the ability to limit the duration of a workout.

Continue this process to enter or change your WEIGHT (1 through 999 pounds or kilograms) and AGE (1 through 99).

•Press QuickStart — By pressing QuickStart at the PRECOR banner, you access the MANL (Manual) course. You can also press QuickStart during Setup mode to pro- cess any selection that appears on the display and any prior entries you may have made.

CAUTION:Hold onto the handrail because the belt starts moving after a short warning message appears on the display,“Belt Starting 3, 2, 1,...”

5.If you pressed SELECT to answer all the Setup prompts, hold onto the handrail with one hand while you press the SPEED ▲ key with the other hand. Step onto the running belt while the speed is at 1 mph (1.5 kph). Once you are comfortable with the walking or running speed, you can remove your hands from the handrail.

page 37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents C932 Important Safety Instructions Grounding Instructions Safety ApprovalTable of Contents Back cover C932 KeypadEuropean Applications Radio Frequency Interference RFIAbout this Manual Obtaining ServiceStandard Equipment Unpacking the TreadmillOther Equipment Acquire Additional Tools Hardware KITOr crescent wrench Installation Requirements Setting Up the TreadmillAssembly Instructions To assemble the treadmill, take the following stepsM M E R C I a L P R O D U C T S D I V I S I O N M M E R C I a L O D U C T S V I S I O N Diagram 7 Install the display console Diagram Follow steps 9a. through 9d. on the opposite side M M E R C I a L O D U C T S V I S I O N Level the unit Turning the Unit on and OFF If the running belt Then Checking the Alignment of the Running BeltClub Information Always start at the scrolling Precor banner Programming TipsDetermining the Units of Measure Selecting the LanguageSetting a Pause Time Limit Setting a Workout Time LimitDetermining the Club Speed Limit RESET, Speed , Select Setting a Cool Down Time LimitER33 AT 12,345,678 Miles 1,714 Hours C932 Display Features on the Display ConsoleTo continue in Setup mode, press Select Setup Mode and PromptsIf QuickStart is pressed at Following occurs Setup Mode and the Quickstarttm FeatureCenter Display During a Workout M M E R C I a L P R O D U C T S D I V I S I O N Keypad Tips C932 KeypadSpecial Keypad Functions AT the Precor Banner Keypad keys Keys on the KeypadSmartRate display will appear when a user wears Setup Prompts Default ValueRefer to Obtaining Service on Polar chest strap. If no Age entry occurs, thenChanging the Display Features Using the Select KEY Using the Security Clip Safety FeaturesUsing the Handrails Exercising on the C932Reviewing Keypad and Workout Tips Using the Stop ButtonKeypad Tips Workout TipsStraddle belt Quick Steps to Working OUTCooling Down After Your Workout Stop PAUSE, Workout SUMMARY, and Exit FeaturesExits Pause mode and starts the running Features remain, so you can review yourCourse where you left off To a gradual stop. Note that you may alsoC932 Courses Course FeaturesManual Manl Course DescriptionsWeight Loss Wtls Heart Rate Capabilities Using the Smartrate FeatureHeart Rate Target Zones Heart Rate Course Cleaning the Equipment MaintenanceInspection Aligning the Running BeltM M E R C I a L P R O D U C T S D I V I S I O N Storing the Polar Chest Strap Servicing the TreadmillLong Term Storage View 1 of 8 C932View 2 of 8 View 3 of 8 View 4 of 8 View 5 View 6 View 7 of 8 View 8 of 8 Thank You and Welcome to Precor Product Serial Numbers Date of Purchase Purchased from Dealer namePlease indicate the type and number of products purchased How many members do you have?Warranty Periods and Coverage Limited WarrantyConditions and Restrictions Complete this portion and keep for your recordsProduct Features Product SpecificationsElectronic Specifications
Top Page Image Contents