Precor C932 owner manual Level the unit

C O M M E R C I A L		P R O D U C T S	D I V I S I O N
Diagram 13 Tighten the handrail	1		2
fasteners.
Handrail end cap
Center handrail
clamp screws (2)
	3
Center console
bracket screws (4)

14.Tighten all the center handrail fasteners. Diagram 13. Start with tightening the two end cap screws and work inward. See Diagram 13, #1. So that you don’t overtighten the fasteners, hold the supplied hex key by its 3-inch section and tighten the two center clamp screws. Refer to Diagram 13, #2. Next, tighten the four console bracket screws. Refer to Diagram 13, #3.

Diagram 14

Level the unit.

1	2
	3

15.Level the unit. Diagram 14.The C932 has adjustable rear feet. Check to make sure that the running surface is level (use a bubble level as shown in Diagram 14). If the treadmill is placed on a slightly, uneven surface, adjusting the rear feet can help, but will not compensate for extremely uneven surfaces.

Important: If you need to make adjustments, adjust one rear foot at a time. Do not use the rear foot to raise or lower the unit more than ¾-inches. Check the level of the unit after each adjustment.

16.Adjust the rear deck. Diagram 14, #3. To raise the rear deck, insert the ¼-inch hex key (G). Make sure that the key is fully engaged and turn it clockwise. Turning the hex key counterclockwise lowers the unit.

page 17