C O M M E R C I A L P R O D U C T S D I V I S I O N
Setting Up the Treadmill
You do not need any special knowledge or experience to set up the treadmill. However, you will need assistance during assembly.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the treadmill. If you do not install the treadmill according to the following guidelines, you could void the Precor limited warranty.
•Set up the treadmill on a solid, flat surface. Unpack and assemble the treadmill close to where you plan to use it. Make sure that the surface under the unit is smooth and level. A level unit is required for the user’s safety and proper operation.
•Provide ample space around the unit. Open space around the unit makes for a safer mount and dismount.
•Fill out and mail the limited warranty card.The serial number can be found on the shipping container or on the label near the power receptacle. Write the serial number onto the Precor limited warranty card found inside the back cover of this manual and in the Obtaining Service section on page 7.
•Use the appropriate voltage, dedicated circuit, and grounding as speci- fied on the treadmill. A 20 amp dedicated circuit is recommended.
ASSEMBLY INSTRUCTIONS
To assemble the treadmill, take the following steps.
1.Obtain adult assistance. Have your assistants help place the shipping carton close to the location where you plan to use the treadmill. Break down the side walls of the shipping carton so that they lie flat. Remove the loose contents.
2.Make sure that the power switch is OFF. Check the ON/OFF power switch on the front of the treadmill. Place the switch in the O (OFF) position. Make sure that the treadmill is not plugged into a power source.
Diagram 3 Lift the rear of the unit and roll it to its assembly location.
End cap
Lift rear by placing hands on opposite sides of the cross brace that is found under the rear cover.
page 10