Precor C932 Setup Mode and the Quickstarttm Feature, If QuickStart is pressed at Following occurs

Page 28

C O M M E R C I A L P R O D U C T S D I V I S I O N

150 LB (68 KG): Acceptable weight entries range from 1 through 999 (pounds or kilograms). Change the number using the ▼ and ▲ keys or accept the displayed number (and continue in Setup mode) by pressing SELECT.

Important: Enter a number that reflects a user’s actual weight since the calorie count and several other calculations are based on the weight entry.

AGE 0: The age prompt appears if the heart rate receiver is properly installed in the display console. Acceptable entries range from 1 to 99. Change the blinking number using the ▼ and ▲ keys or accept the displayed number by pressing SELECT.

Important: An age entry is required if the user wants to use the heart rate capa- bilities of the treadmill. Refer to Heart Rate Capabilities on page 44.

THE SETUP MODE AND THE QUICKSTARTTM FEATURE

The QuickStart feature can be pressed any time during the Setup prompts. Since the QuickStart program accesses factory default values (refer to Club Information on page 20) and assumes the age value is equal to zero, the SmartRate program is disabled. However, the values that the QuickStart program uses are dependent on when a user presses QuickStart in the Setup mode. See the table below.

CAUTION: Pressing the QuickStart key at the PRECOR banner or after any one of the Setup prompts causes the running belt to begin moving auto- matically. Hold onto the handrail because the belt starts moving after a short warning message scrolls across the display,“Belt Starting 3, 2, 1,...”

If QuickStart is pressed at the:

The following occurs:

 

 

PRECOR banner

The user bypasses the Setup prompts

 

altogether and starts working out using

 

the Manual course. Default values apply.

Course prompt

The profile associated with the course

 

name (MANL, INTV, WTLS, etc.) appears

 

on the display and becomes the user’s

 

selection for their workout.

Workout Time prompt

The information (XX MIN) that appears

 

on the display becomes the workout time

 

for the course. A user can change the dis-

 

play using the▼ or ▲ keys.See WorkoutTips.

Note: A user can select an indefinite workout time, if the Club allows it. By pressing either ▼▲ key, the word “NOLIM” appears on the display where the number zero would normally appear (between 99 and 1). Refer to Club Information on page 20.

page 28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents C932 Important Safety Instructions Safety Approval Grounding InstructionsTable of Contents C932 Keypad Back coverRadio Frequency Interference RFI European ApplicationsObtaining Service About this ManualStandard Equipment Unpacking the TreadmillOther Equipment Acquire Additional Tools Hardware KITOr crescent wrench Setting Up the Treadmill Installation RequirementsAssembly Instructions To assemble the treadmill, take the following stepsM M E R C I a L P R O D U C T S D I V I S I O N M M E R C I a L O D U C T S V I S I O N Diagram 7 Install the display console Diagram Follow steps 9a. through 9d. on the opposite side M M E R C I a L O D U C T S V I S I O N Level the unit Turning the Unit on and OFF Checking the Alignment of the Running Belt If the running belt ThenClub Information Programming Tips Always start at the scrolling Precor bannerSelecting the Language Determining the Units of MeasureSetting a Pause Time Limit Setting a Workout Time LimitDetermining the Club Speed Limit Setting a Cool Down Time Limit RESET, Speed , SelectER33 AT 12,345,678 Miles 1,714 Hours Features on the Display Console C932 DisplaySetup Mode and Prompts To continue in Setup mode, press SelectSetup Mode and the Quickstarttm Feature If QuickStart is pressed at Following occursCenter Display During a Workout M M E R C I a L P R O D U C T S D I V I S I O N Keypad Tips C932 KeypadSpecial Keypad Functions AT the Precor Banner Keys on the Keypad Keypad keysSetup Prompts Default Value SmartRate display will appear when a user wearsRefer to Obtaining Service on Polar chest strap. If no Age entry occurs, thenChanging the Display Features Using the Select KEY Safety Features Using the Security ClipUsing the Handrails Exercising on the C932Using the Stop Button Reviewing Keypad and Workout TipsKeypad Tips Workout TipsQuick Steps to Working OUT Straddle beltCooling Down After Your Workout PAUSE, Workout SUMMARY, and Exit Features StopFeatures remain, so you can review your Exits Pause mode and starts the runningCourse where you left off To a gradual stop. Note that you may alsoCourse Features C932 CoursesCourse Descriptions Manual ManlWeight Loss Wtls Using the Smartrate Feature Heart Rate CapabilitiesHeart Rate Target Zones Heart Rate Course Maintenance Cleaning the EquipmentInspection Aligning the Running BeltM M E R C I a L P R O D U C T S D I V I S I O N Storing the Polar Chest Strap Servicing the TreadmillLong Term Storage C932 View 1 of 8View 2 of 8 View 3 of 8 View 4 of 8 View 5 View 6 View 7 of 8 View 8 of 8 Thank You and Welcome to Precor Date of Purchase Purchased from Dealer name Product Serial NumbersPlease indicate the type and number of products purchased How many members do you have?Limited Warranty Warranty Periods and CoverageConditions and Restrictions Complete this portion and keep for your recordsProduct Features Product SpecificationsElectronic Specifications
Top Page Image Contents