Precor C932 owner manual Center Display During a Workout

Page 29

C O M M E R C I A L P R O D U C T S D I V I S I O N

Table continued...

If QuickStart is pressed at the:

The following occurs:

 

 

Weight prompt

The weight (150LB or 68KG) that appears

 

on the display becomes the designated weight

 

that the C932 uses to compute various cal

 

culations.A user can change the display from

 

1 through 999 using the or keys.

Age prompt

The age prompt (AGE 0) that appears on

 

the display becomes the designated age that

 

the C932 uses for SmartRate® system. A

 

correct age entry between 1 and 99 is very

 

important if a user plans to use the heart

 

rate characteristics of the treadmill. The

 

QuickStart key acts the same as the

 

SELECT key at this point because the user

 

has answered all the Setup prompts.

CENTER DISPLAY DURING A WORKOUT

The PRECOR banner, setup prompts, course profiles and feature selections appear in the center display. Prior to working out, prompts guide the user through the Setup mode. Refer to Setup Mode and Prompts.

Once a user begins a workout, the SCAN LED is lit indicating that all highlighted features (PROFILE, TIME, DISTANCE, etc.) will appear consecutively on the display. A user can change what features are scanned by pressing the SELECT key. Refer to Changing the Display Features Using the SELECT Key on page 34.

The following describes the information that can appear in the display.

PROFILE: At the beginning of a course, the profile appears on the right side of the display and corresponds to the course that has been selected. As a user proceeds through the workout, a blinking column indicates his or her position in the course. The height of the column indicates the level of incline. Every time the incline changes by several sequential levels (up or down) the height of the col- umn changes by one cell.

TIME: A time (0:00) display appears when a user begins working out. TIME ap- pears in minutes and seconds. However, should a user exceed 60 minutes (dur- ing a single workout), the TIME display converts to hours and minutes. Most often, the TIME display shows the amount of time remaining in a workout.

DISTANCE: The distance that a user has traveled appears (00.00) once a work- out begins. Distance can appear in miles or kilometers. If the user wishes to change the display, they will need to contact the club manager or owner. Refer to the instructions found in Club Information on page 20.

page 29

Image 29
Contents C932 Important Safety Instructions Grounding Instructions Safety ApprovalTable of Contents Back cover C932 KeypadEuropean Applications Radio Frequency Interference RFIAbout this Manual Obtaining ServiceOther Equipment Unpacking the TreadmillStandard Equipment Or crescent wrench Hardware KITAcquire Additional Tools Installation Requirements Setting Up the TreadmillAssembly Instructions To assemble the treadmill, take the following stepsM M E R C I a L P R O D U C T S D I V I S I O N M M E R C I a L O D U C T S V I S I O N Diagram 7 Install the display console Diagram Follow steps 9a. through 9d. on the opposite side M M E R C I a L O D U C T S V I S I O N Level the unit Turning the Unit on and OFF If the running belt Then Checking the Alignment of the Running BeltClub Information Always start at the scrolling Precor banner Programming TipsDetermining the Units of Measure Selecting the LanguageDetermining the Club Speed Limit Setting a Workout Time LimitSetting a Pause Time Limit RESET, Speed , Select Setting a Cool Down Time LimitER33 AT 12,345,678 Miles 1,714 Hours C932 Display Features on the Display ConsoleTo continue in Setup mode, press Select Setup Mode and PromptsIf QuickStart is pressed at Following occurs Setup Mode and the Quickstarttm FeatureCenter Display During a Workout M M E R C I a L P R O D U C T S D I V I S I O N Special Keypad Functions AT the Precor Banner C932 KeypadKeypad Tips Keypad keys Keys on the KeypadSmartRate display will appear when a user wears Setup Prompts Default ValueRefer to Obtaining Service on Polar chest strap. If no Age entry occurs, thenChanging the Display Features Using the Select KEY Using the Security Clip Safety FeaturesUsing the Handrails Exercising on the C932Reviewing Keypad and Workout Tips Using the Stop ButtonKeypad Tips Workout TipsStraddle belt Quick Steps to Working OUTCooling Down After Your Workout Stop PAUSE, Workout SUMMARY, and Exit FeaturesExits Pause mode and starts the running Features remain, so you can review yourCourse where you left off To a gradual stop. Note that you may alsoC932 Courses Course FeaturesManual Manl Course DescriptionsWeight Loss Wtls Heart Rate Capabilities Using the Smartrate FeatureHeart Rate Target Zones Heart Rate Course Cleaning the Equipment MaintenanceInspection Aligning the Running BeltM M E R C I a L P R O D U C T S D I V I S I O N Long Term Storage Servicing the TreadmillStoring the Polar Chest Strap View 1 of 8 C932View 2 of 8 View 3 of 8 View 4 of 8 View 5 View 6 View 7 of 8 View 8 of 8 Thank You and Welcome to Precor Product Serial Numbers Date of Purchase Purchased from Dealer namePlease indicate the type and number of products purchased How many members do you have?Warranty Periods and Coverage Limited WarrantyConditions and Restrictions Complete this portion and keep for your recordsElectronic Specifications Product SpecificationsProduct Features