Precor C932 owner manual M M E R C I a L P R O D U C T S D I V I S I O N

Page 30

C O M M E R C I A L P R O D U C T S D I V I S I O N

Note: If a user were to exceed 65.53 miles (or kilometers) in a single workout, the numerical display resets to zero and begins over again.

CALORIES: Provides an estimate of the cumulative number of calories burned. The calorie calculation is derived from the speed, incline level, and a user’s weight. An accurate weight entry results in a more accurate calorie count.

SPEED: Displays the running belt’s speed. The ▼ and ▲ keys let a user de- crease or increase the treadmill’s speed.The running belt speed ranges from 0.5 to 11.0 mph (1.0 to 18.0 kph) and can be changed in 0.1 increments.

Note: A user can check the speed (when it is not the chosen display) any time during a workout by tapping either SPEED ▼ or ▲ key. Pressing and holding the SPEED ▼ or ▲ key causes the treadmill’s speed to change. Refer to Keys on the Keypad on page 32.

INCLINE: Displays the percent of incline during a workout. The INCLINE ▲ and

▼keys affect the treadmill’s lift and let a user set an incline between 0% and 15.0%. The values displayed can change in 0.5% increments.

Note: A user can check the incline (when it is not the chosen display) any time during a workout by tapping either INCLINE ▲ and ▼ key. Pressing and holding the INCLINE ▲ and ▼ key causes the treadmill’s incline to change. Refer to Keys on the Keypad.

HR: The heart rate display lets a user monitor his or her heart rate. When a heart beat is detected, the number appears when the display scans HR (Heart Rate).The indicator (LED) light next to the HR label pulses whenever the heart rate receiver detects the user’s pulse.If a user is not wearing a POLAR® chest strap, the heart rate will not be detected and no pulse rate appears (the display remains blank).

Important: If a “— — —” appears in the display, the C932 is having difficulty detecting a user’s heart rate. Make sure that the POLAR® chest strap is posi- tioned properly on a user’s chest against the skin. If the heart rate receiver in the display console has become disconnected, the display appears blank. Refer to the Heart Rate Capabilities on page 44.

SmartRate® display: Once a course begins, a blinking column segment along the right edge of the display approximates a user’s heart rate and shows which zone the user’s heart rate is in: weight loss or cardiovascular.

•Weight Loss Zone: Maintaining a heart rate between 55% and 70% of a user’s maximum aerobic heart rate, helps burn enough calories that, when continued on a regular basis for 30 minutes or more, provides the greatest fat-burning results.The yellow LED’s on the SmartRate® display indicate the Weight Loss zone.

•Cardiovascular Zone: Maintaining a heart rate between 70% and 85% of a user’s maximum aerobic heart rate, helps (when continued on a regular basis for 30 minutes or more) improve a user’s overall cardiovascular/car- diorespiratory fitness level. The green LED’s on the SmartRate® display in- dicate the Cardiovascular zone.

page 30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents C932 Important Safety Instructions Safety Approval Grounding InstructionsTable of Contents C932 Keypad Back coverRadio Frequency Interference RFI European ApplicationsObtaining Service About this ManualUnpacking the Treadmill Standard EquipmentOther Equipment Hardware KIT Acquire Additional ToolsOr crescent wrench Assembly Instructions Setting Up the TreadmillInstallation Requirements To assemble the treadmill, take the following stepsM M E R C I a L P R O D U C T S D I V I S I O N M M E R C I a L O D U C T S V I S I O N Diagram 7 Install the display console Diagram Follow steps 9a. through 9d. on the opposite side M M E R C I a L O D U C T S V I S I O N Level the unit Turning the Unit on and OFF Checking the Alignment of the Running Belt If the running belt ThenClub Information Programming Tips Always start at the scrolling Precor bannerSelecting the Language Determining the Units of MeasureSetting a Workout Time Limit Setting a Pause Time LimitDetermining the Club Speed Limit Setting a Cool Down Time Limit RESET, Speed , SelectER33 AT 12,345,678 Miles 1,714 Hours Features on the Display Console C932 DisplaySetup Mode and Prompts To continue in Setup mode, press SelectSetup Mode and the Quickstarttm Feature If QuickStart is pressed at Following occursCenter Display During a Workout M M E R C I a L P R O D U C T S D I V I S I O N C932 Keypad Keypad TipsSpecial Keypad Functions AT the Precor Banner Keys on the Keypad Keypad keysRefer to Obtaining Service on Setup Prompts Default ValueSmartRate display will appear when a user wears Polar chest strap. If no Age entry occurs, thenChanging the Display Features Using the Select KEY Using the Handrails Safety FeaturesUsing the Security Clip Exercising on the C932Keypad Tips Using the Stop ButtonReviewing Keypad and Workout Tips Workout TipsQuick Steps to Working OUT Straddle beltCooling Down After Your Workout PAUSE, Workout SUMMARY, and Exit Features StopCourse where you left off Features remain, so you can review yourExits Pause mode and starts the running To a gradual stop. Note that you may alsoCourse Features C932 CoursesCourse Descriptions Manual ManlWeight Loss Wtls Using the Smartrate Feature Heart Rate CapabilitiesHeart Rate Target Zones Heart Rate Course Inspection MaintenanceCleaning the Equipment Aligning the Running BeltM M E R C I a L P R O D U C T S D I V I S I O N Servicing the Treadmill Storing the Polar Chest StrapLong Term Storage C932 View 1 of 8View 2 of 8 View 3 of 8 View 4 of 8 View 5 View 6 View 7 of 8 View 8 of 8 Thank You and Welcome to Precor Please indicate the type and number of products purchased Date of Purchase Purchased from Dealer nameProduct Serial Numbers How many members do you have?Conditions and Restrictions Limited WarrantyWarranty Periods and Coverage Complete this portion and keep for your recordsProduct Specifications Product FeaturesElectronic Specifications
Top Page Image Contents