Precor C932 owner manual Setup Mode and Prompts, To continue in Setup mode, press Select

Page 27

C O M M E R C I A L P R O D U C T S D I V I S I O N

The SmartRate® and Heart Rate system is standard equipment. The heart rate receiver is factory-installed in the display console.To actively view the SmartRate® and heart rate displays, a user must wear a POLAR® chest strap, face the dis- play console, enter his or her age (during the Setup prompts), and begin a course. The user’s heart rate is transmitted from the chest strap to the receiver inside the console and appears on the display. A blinking segment approximates the user’s heart rate and shows which zone the heart rate is in: weight loss or cardiovascular.

Important: During a course, a user’s heart rate must be above 40 beats per minute before the segment begins to blink. Note that pressing QuickStart at the PRECOR banner causes the SmartRate® display feature to be inactive.

SETUP MODE AND PROMPTS

The PRECOR banner is the “starting point” when a user begins a workout. If the banner does not scroll across the display, press the RESET key. If the display appears blank, make sure that the treadmill is turned ON. Press the ON/OFF [I/O] switch located at the front, near the power receptacle, to ON.

PRECOR banner: From the PRECOR banner, a user presses the SELECT key to access the Setup mode which lets a user determine the course, workout time, weight, and age parameters as described below.

Note: Key presses to the INCLINE ▼▲ or SPEED ▼▲ keys are ignored when the banner is being displayed. Refer to page 30 for more information about the keypad.

MANL: The course prompt, MANL, indicates that the C932 is ready to accept course entries. To help a user determine which course they want to use, the course names and profiles appear on the display console label. The ▼ and ▲ keys let a user scroll through the available courses. The display presents the abbreviated name of the course. To choose the selection being displayed and continue in Setup mode, press SELECT. (Refer to The Setup Mode and the QuickStart Feature on page 28.)

Note: Depending on the course that is selected, a user may be prompted for other information. Refer to C932 Courses on page 40.

XXMIN: Acceptable entries at the workout time prompt range between NOLIM (zero) and 99 minutes. Use the ▼ and ▲ keys to change the selection. If the club allows it and a user wants to work out indefinitely, they can choose NOLIM. A cool-down period will not be appended to the course. Note that the Weight Loss course has a preset time limit so a user will not be prompted for a workout time when they choose WTLS. A user cannot workout indefinitely in the Weight Loss course.

To continue in Setup mode, press SELECT.

Important:The club has the option to set limits on course duration and cool down and pause time. Refer to Club Information on page 20.

page 27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents C932 Important Safety Instructions Grounding Instructions Safety ApprovalTable of Contents Back cover C932 KeypadEuropean Applications Radio Frequency Interference RFIAbout this Manual Obtaining ServiceUnpacking the Treadmill Standard EquipmentOther Equipment Hardware KIT Acquire Additional ToolsOr crescent wrench To assemble the treadmill, take the following steps Setting Up the TreadmillInstallation Requirements Assembly InstructionsM M E R C I a L P R O D U C T S D I V I S I O N M M E R C I a L O D U C T S V I S I O N Diagram 7 Install the display console Diagram Follow steps 9a. through 9d. on the opposite side M M E R C I a L O D U C T S V I S I O N Level the unit Turning the Unit on and OFF If the running belt Then Checking the Alignment of the Running BeltClub Information Always start at the scrolling Precor banner Programming TipsDetermining the Units of Measure Selecting the LanguageSetting a Workout Time Limit Setting a Pause Time LimitDetermining the Club Speed Limit RESET, Speed , Select Setting a Cool Down Time LimitER33 AT 12,345,678 Miles 1,714 Hours C932 Display Features on the Display ConsoleTo continue in Setup mode, press Select Setup Mode and PromptsIf QuickStart is pressed at Following occurs Setup Mode and the Quickstarttm FeatureCenter Display During a Workout M M E R C I a L P R O D U C T S D I V I S I O N C932 Keypad Keypad TipsSpecial Keypad Functions AT the Precor Banner Keypad keys Keys on the KeypadPolar chest strap. If no Age entry occurs, then Setup Prompts Default ValueSmartRate display will appear when a user wears Refer to Obtaining Service onChanging the Display Features Using the Select KEY Exercising on the C932 Safety FeaturesUsing the Security Clip Using the HandrailsWorkout Tips Using the Stop ButtonReviewing Keypad and Workout Tips Keypad TipsStraddle belt Quick Steps to Working OUTCooling Down After Your Workout Stop PAUSE, Workout SUMMARY, and Exit FeaturesTo a gradual stop. Note that you may also Features remain, so you can review yourExits Pause mode and starts the running Course where you left offC932 Courses Course FeaturesManual Manl Course DescriptionsWeight Loss Wtls Heart Rate Capabilities Using the Smartrate FeatureHeart Rate Target Zones Heart Rate Course Aligning the Running Belt MaintenanceCleaning the Equipment InspectionM M E R C I a L P R O D U C T S D I V I S I O N Servicing the Treadmill Storing the Polar Chest StrapLong Term Storage View 1 of 8 C932View 2 of 8 View 3 of 8 View 4 of 8 View 5 View 6 View 7 of 8 View 8 of 8 Thank You and Welcome to Precor How many members do you have? Date of Purchase Purchased from Dealer nameProduct Serial Numbers Please indicate the type and number of products purchasedComplete this portion and keep for your records Limited WarrantyWarranty Periods and Coverage Conditions and RestrictionsProduct Specifications Product FeaturesElectronic Specifications
Top Page Image Contents