MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise bike regu- larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace all the batteries at the same time. See assembly step 6 on page 8 for replacement instructions.
If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the left pedal, the left disc cover, and the left pedal disc (see the instructions below).
Using an adjustable wrench, turn the left pedal clock- | |||
wise and remove it. |
|
|
|
Next, rotate the |
|
|
|
Left Crank Arm |
|
|
|
(20) to a vertical |
|
|
|
position with the |
|
|
|
end of the Left |
|
|
|
Crank Arm point- | 20 |
| 18 |
ing downward. |
| ||
Using a flat |
| Tab | Tab |
screwdriver, |
| ||
release the tabs |
|
|
|
on each point of |
|
|
|
the left Disc |
|
|
|
Cover (18). Carefully work the left Disc Cover over the | |||
Left Crank Arm (20) and remove the left Disc Cover. | |||
Next, rotate the Left |
|
|
Crank Arm (20) to a | 20 |
|
vertical position with |
| |
the end of the Left |
|
|
Crank Arm pointing |
|
|
upward. Rotate the |
| 11 |
left Pedal Disc (17) | 17 | |
clockwise to release |
| |
it from the Left Shield |
|
|
(11). Then, work the |
|
|
left Pedal Disc upward and remove it from the Left | ||
Crank Arm (20). |
|
|
Locate the Reed Switch (57). Loosen, but do not remove, the two M4 x 12.7mm Flange Screws (63).
55 | 57 | 20 |
| 63 |
|
Next, rotate the Left Crank Arm (20) until a Magnet (55) is aligned with the Reed Switch (57). Slide the Reed Switch slightly toward or away from the Magnet. Then, retighten the M4 x 12.7mm Flange Screws (63). Rotate the Left Crank Arm (20) for a moment. Repeat these actions until the console displays correct feed- back.
When the reed switch is correctly adjusted, reattach the left pedal disc, the left disc cover, and the left pedal.
19