OK
TIME
Fig. 4.33. Setting Backlight On Time. Press scroll buttons to change backlight on/off and to set time value.
m 
ft
OK
°C
°F
Fig. 4.34. Setting Metric/ Imperial units.
NOTE! When the backlight turned OFF, it does not illuminate when an alarm is given.
4.3.3.2.Dive Computer Units Setting [2 UNITS]
To enter the Dive Computer Units Setting mode, select MODE- 3 SET- 3 SET PREF- 2 UNITS. This will enable you to choose between metric and imperial units (Fig. 4.34.).
4.3.3.3.Wireless Transmission Settings [3 HP]
The wireless transmission can be set “ON” or “OFF” depending on if the optional wireless pressure transmitter is used or not. No cylinder pressure related data is shown or data recep- tion made when this selection is “off”.
You can set the secondary cylinder pressure alarm point. The 50 bar alarm is fixed and can- not be changed. The 35 bar secondary alarm pressure can be set in the range 10
4.3.3.4.Profile Sample Rate Setting [4 REC]
OK
You can set dive profile sample rate to 10, 20, 30 or 60 seconds. To adjust the sampling rate select MODE- 3 SET- 3 SET PREF- 4 REC. The factory default setting is 20 seconds.
4.3.3.5.Dive Computer Model Setting [5 MODEL] –
AIR/NITROX/GAUGE
Fig. 4.35. Setting Dive Computer model.
In the Dive Computer Model Setting mode the 
dive computer can be set to be an AIR computer, 
NITROX computer or a depth GAUGE with a timer
(Fig. 4.35.).
To enter the Dive Computer Model Setting mode select MODE- 3 SET- 3 SET PREF- 5 MODEL.
56